When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
What do you mean "about to pull the trigger"? I would have assumed you already found your vendor and on the verge of paying... so you are still evaluating/selecting/researching.
Originally Posted by 99-911
I'm too about to pull the trigger on PIWIS 2 hardware + software, any recommended vendor?
I'm too about to pull the trigger on PIWIS 2 hardware + software, any recommended vendor?
I used rnlst and I can recommend based on response time to questions and ease of installation, but if you’re not very tech savvy and don’t have experience with computers you may need some additional guidance which he can provide or I’m happy to help if needed.
its piwis 3 and I believe the latest version, just waiting for hardware to arrive tomorrow.
I'm too about to pull the trigger on PIWIS 2 hardware + software, any recommended vendor?
@rnlst_log is the guy. You need to contact him with what cars you have. Purchase a certified laptop from Amazon send it to @rnlst_log done! He is always there to support.
Be careful with your VAS 6154. I just broke the USB connector off inside mine. Barely bumped the cable with my foot. Connector broke off the circuit board. Not something that can be easily repaired. Looks like I need to buy a replacement. Any suggestions for a reliable source?
Be careful with your VAS 6154. I just broke the USB connector off inside mine. Barely bumped the cable with my foot. Connector broke off the circuit board. Not something that can be easily repaired. Looks like I need to buy a replacement. Any suggestions for a reliable source?
Be careful with your VAS 6154. I just broke the USB connector off inside mine. Barely bumped the cable with my foot. Connector broke off the circuit board. Not something that can be easily repaired. Looks like I need to buy a replacement. Any suggestions for a reliable source?
Soldering a USB is usually pretty simple. If you want to include a close up photo of the damage I could tell you whether you could just buy a new USB port and solder it.
Can confirm the USB port is fragile but it was also pretty straightforward to re-solder whine mine fell off. I did make some modifications to stabilize the port by adding some foam padding and hot glue.
Thanks, but the connector pulled off some of the printed connections. It could be resoldered, but I don't have the ability to repair the damaged printing. I will use it in Wifi mode.
Even with ripped pads it's still possible to repair, the traces are not complicated to just run small wires. I would find a shop that can do microsoldering. I'd offer to do it but I'd rather you have someone who would offer you a warranty with their workmanship!
Be careful with your VAS 6154. I just broke the USB connector off inside mine. Barely bumped the cable with my foot. Connector broke off the circuit board. Not something that can be easily repaired. Looks like I need to buy a replacement. Any suggestions for a reliable source?
Just use it with WiFi. I broke mine off as well. Also consider migrating to the T6PT3G; lightning speed
Piwis 3 automatic coding do not work, I got error during F-TAB , I have researched without result about solution.
please help me!
in which direction I need to go?
Any help is much appreciated 😉