Any Rennlisters from New Zealand?
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
1901 pages, 28,504 replies and 805,305 views.
Drifting
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
I have the deep sixes, some cookies and will get a set of 7x15 fuchs.
Drifting
Drifting
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
![Name: sexy-smokey-eye-make-up.jpg
Views: 147
Size: 23.7 KB](https://rennlist.com/forums/attachments/rennlist-asia-pacific/961948d1439242766-any-rennlisters-from-new-zealand-sexy-smokey-eye-make-up.jpg)
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
It appears to have accelerated when the RSG concept was born. A few Porsche nuts finding a common group - now multiple car ownership isn't unusual.
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Btw Warwick, I don't think it's possible to do an engine drop with just newbies, at least not unless you have multiple days.
The good news is that I can help others now when I finally finish.
Last night was a pivotal point. I managed to get both half shafts disconnected after many hours of trying with the last two bolts. Oil line tonight will be the last big hurdle.
After that it's small connectors. The drop itself should be easy.
I made a support out of plywood and a routered board to cradle the engine when it comes out with the ATV jack. I think I could almost do this solo except the ATV jack only drops 25cm and there is more engine height than that to clear. Once the engine is on the ATV jack there's no obvious place to use the AC Jack to get it higher. I will have to call in some muscle.
The good news is that I can help others now when I finally finish.
Last night was a pivotal point. I managed to get both half shafts disconnected after many hours of trying with the last two bolts. Oil line tonight will be the last big hurdle.
After that it's small connectors. The drop itself should be easy.
I made a support out of plywood and a routered board to cradle the engine when it comes out with the ATV jack. I think I could almost do this solo except the ATV jack only drops 25cm and there is more engine height than that to clear. Once the engine is on the ATV jack there's no obvious place to use the AC Jack to get it higher. I will have to call in some muscle.
Last edited by John McM; 08-10-2015 at 08:44 PM.