When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
It's the rennsport magnetic mount. The MagSafe attaches to that magnetically without any additional requirements. Occasionally it will slide off if you pull the phone sideways, but it's been reliable so far. You can always add a PSA to secure it if needed.
I have a SpiegeL mount (bought directly from Spiegel for the V2 that has 50% more magnet power) on a modified Rennline dash mount with a SpiegeN MagSafe case. I hated the white MagSafe outline on other clear cases.
It isn’t going anywhere. I don’t even think a car accident would knock it off.
Last edited by ATX_Native; 05-19-2021 at 01:12 PM.
It's the rennsport magnetic mount. The MagSafe attaches to that magnetically without any additional requirements. Occasionally it will slide off if you pull the phone sideways, but it's been reliable so far. You can always add a PSA to secure it if needed.
Sweet! I might have to do this. I have the Rennsport magnetic mount and always pull out the corder charger to charge the phone.
Finally got rid of the terrible Bose factory amp and fiber optic garbage. To eliminate the MOST adapter box attached to my Sony XAV-AX5000, I installed a JBL DSP4086 amp to power the factory Bose speakers using a Bose amp bypass wiring harness... it's an incredible upgrade. The JBL amp allows you to tune the frequencies of each speaker and assign the appropriate low level line out signal to each channel through a computer interface, shown in the pic. I opted against reinstalling the Bose subwoofer box, as the woofers in the doors provide more than enough bass for my needs now and I see no need to carry the extra weight/volume in the rear of the cabin. Aside from soldering up the wiring harness and running RCA cables and a remote power wire from the back of the receiver to the amp in the frunk, it's plug 'n play. Can't recommend this enough if you've moved on from the factory PCM unit.
I have a SpiegeL mount (bought directly from Spiegel for the V2 that has 50% more magnet power) on a modified Rennline dash mount with a SpiegeN MagSafe case. I hated the white MagSafe outline on other clear cases.
It isn’t going anywhere. I don’t even think a car accident would knock it off.
I like that set up. How exactly did you modify the RennLine mount to make this work? I've already got the RL installed...