When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
^^ wow dream spec there. Everything works together perfectly down to the bright exhaust tips & all red taillights!
Yesterday, I got around to taking out the winter rubber floor mats and putting in a set of Cocomats, then wrapped the trim ring on my steering wheel in black.
Well didn't do this all today but more like this week. Finally got to put my wheels on and install my Numeric shifter...it's almost too short of a throw now😂😂
Not the best pics.. but after replacing my console with Alcantara I had some of the other worn out trim pieces swapped out with fresh meteor gray metallic painted trim from Bumperplugs.
Installed the 991.1 Sport Design lip using @Emc2design 's adapter kit 👌🏻 Already “baptized” the lip, scraping it in the driveway 😬😅 Two small non-essential pieces broke off from the lip’s back, but the overall adapter kit holds strong! 👌🏻 Fortunately these parts are made with wear and tear in mind, so I’m not upset about it.
Hooked up with a few regulars and took a drive out to Rush Valley (SW of SLC). Long stretches of open road and a fun little pass to climb, descend, repeat...
Did the paddle shift mod. (They look uneven in the photo due to the angle). Retained original tiptronic buttons and they are also functional. Time and $ we’ll spent.
What i did to my Silver 911 over the past 90 days.
Just finished the Yuge upgrade project on my 07 C4S and could not be happier with the outcome. She was lowered when i got her and the bottom was scrapping on low clearance situations, the tires were wearing poorly and i just had to fix the situation. She handles like a dream now, tight, responsive and fun to drive.
- Bilstein B14/B16 coil overs
- RSS Tarmac stage 2 suspension kit (control arms, tie rod ends and rear links)
- Tarett drop links
- Elephant Racing solid sub frame bushings
- Front strut brace
- GT3 sways
- DSC Sport PASM Controller
- Set to GT3 ride high/alignment specs
- 19" Flow One Race Spec F2 wheels wiith Pilot Sport 4S rubber
- Aluminum pedals
- Lloyds floor mats
- Oil change
- Trans fluid change
- new starter (old one shorted out)
- New battery cables and Cap bolt (rusted pretty badly)
- ready for the track!!!
Suky the climb all over everything and sit where ever the hell i want to cat. cap bolt cubby hole guess which one is the bad cap bolt? Cleaned up the subframe while replacing bushings uhhh off to see the wizard. Picked her up at the dealer after getting it aligned. first bath after getting her back. out and about for a joy ride out and about for a joy ride out and about for a joy ride