What did you do to your 924/944 today
#318
*It may be worth noting that I did this after a 2hour long drive to the nut and axle was quite heated when I loosened it.
#319
still thinning out wire harness...almost done now. then i have to change a bad injector seal...then see if i can find an oil leak i know i have somewhere. so ill be cleaning the engine bay to make it more obvious.
#320
Scanned the image of my MaxHP chips, modified the maps using MaxTuner, and burned the new image to the ostrich... Oh and went for a short test drive, And put the DME back together and installed it...more tuning tomorrow....After I install my 55lb injectors, 3 bar FPR and new damper.... OH and I cleaned the inside of a used coolant tank I bought... bout half way to where I want to be to install it... just need to finish getting it cleaned up...
#324
Installed a new FPR and Damper. I've been getting black smoke at full throttle, soot in the exhaust, and MPG has been dropping pretty steady from 31 mpg when I bought the car to about 24 now. Hopefully it will improve.
Also installed a LR vacuum hose kit to go with the new FPR and damper. Had to go with "Go Fast" red to match the red magnacore plug wires.
This is all well and good, but the car is still down due to me having to wait for my waterpump and goodies to ship :-( (Paragon always ships fast though ..... Jason is always on the ball)
Also installed a LR vacuum hose kit to go with the new FPR and damper. Had to go with "Go Fast" red to match the red magnacore plug wires.
This is all well and good, but the car is still down due to me having to wait for my waterpump and goodies to ship :-( (Paragon always ships fast though ..... Jason is always on the ball)
#326
Drove the crap out of it today. Must have wasted about half a tank of gas, just moseying around town. Some of it was time spent out cruising with the weekend crowd. Also used it to pick up some chicks, but I got bored with them so I then used it to entertain myself once more.
#327
Did some random jobs in preparation for installing the replacement cylinder head next weekend....I hope. Figured out why my valve cover leaked oil through the plugs, o-rings has basically turned into plastic.