Lemming

Removed the supertrapp exhaust and installed a dynomax turbo muffler on the race car. The neighbors were complaining when I ran the car in the driveway. Not only that but I was getting sick of the raspy sound.

941MXVET

Pealed all of the PO's stickers, racing numbers, and sponsers off to begin preping the car for a new coat of Solar Yellow. Will try and get the car to my friends house where we'll be painting it.

This was my first thing I've done to this car since I've owned it. Love it!

941MXVET

Project pic's:

rdanford

Wash, clay and wax....looks great!

SeaCay

Drained tank and replaced the fuel filter. Tried to get her to start after a long term in storage, and no freakin start... $@#&*%!

Now the fun starts.

sydneyman

Received brake ducts/fog light units from D9 today... trying to figure out how this thing gets installed!

Fintro11

finally mastered taking off and putting back on my sunroof haha

Mighty Shilling

Dyno test. Trying out the new hardware and software. Got 310 hp and 351 ft-lbs with 18 PSI

V2Rocket

torqued control arms on, rebuilt slave cylinder/bled it, installed new ac condenser, ran out of electricity and got another battery under warranty

then it only ran on 3 cylinders??? #2 went out for some reason and then halfway home kicked back on with a surprising bit of thrust..?im thinking stuck injector...

Hollywood D

Put new rear shocks on

F40LM

Installed new balance belt and kevlar timing belt. Replaced the ref sensor, still did not get the tach to wake up. The saga continues.....

ZRDeuce

Finished pulling the head off, so glad I decided to that while fixing a cam cover oil leak, found one sad looking head gasket.

stuntman703

Pulled my AFM off for cleaning. Car starts and just dies, going through the check list.

Mighty Shilling

make sure you re-lubricate the AFM door after cleaning. trust me on this. if it squeaks when you manually open it, LUBRICATE IT. if it still squeaks after lubing, you've ruined it. BTDTGTTS

stuntman703

Can you elaborate more on this. All I did was clean off the strip with an eraser and slightly bent the arm. How would I grease the arm? Also what should I use to clean the contacts, q-tip and alcohol?