V2Rocket

destroyed my steering wheel

harrisonrick

I heard that Hershey was disappointing for 944 owners...not much stuff for our variants.

eric951turbo

- Momo steering
- Boxster 17'' mags + spacers
- New Bridgestone tires
- Rear Hatch window repair (NO MORE NOISE )
- Motor mounts
- Chip (+30Hp)
- Converted to front & back black seat
- Floor mats
- Turbo gauge
- Paint job on the front (no more rock chips)
- Fuel hose regulator rebuilt
- New Fuel pressure hose kit
- Aux water pump
- Front engine seal kit
- Starter
- Balance shaft belt
- timing belt
- Shift Lever
- Roller timing belt tensioner
- Roller Balance shaft
- Crankshaft Seal

And a lot of money

But the car looks and runs great.

Become up: new turbo (pressure is really good, but turbine is lazy)

Geldfalle 944

I began the long process of accumulating parts for my
water pump/timing belts/tensioners/power steering bracket/thermostat/ball joints/door card/wheel painting/dash repair.

thirdgenbird

ive got power steering parts laying around (ALL of them)


today i ordered a front seal kit from paragon.

mhr

Eric,

Nice car!

Second shot is a perfect Montreal scene with the street hockey going on in the background. GO HABS GO!

Dougs951

Finally got the oil cooler housing re-installed. Hopefully I can get the car started in the AM to confirm that it was the problem causing the milkshake. Either way I needed to do the seals, next will be a head job if the milkshake doesn't go away.

PorscheDude1

I had the same concerns after doing my OC seals. After a few oil flushes all was good.
Best of luck to ya!!!

Dougs951

Thanks, I just finished making a 'custom' wrench to tighten the oil cooler lines.

Next I need to do motor mounts. My passenger side is completly gone.

eric951turbo

Thanks!
Man these kids are playing in front of my house each week nights, and 8am to 8pm every weekends.
I always park my P at the end of the drive way because of them : ) Don't want them to do some bad slapshots and puck my P.

V2Rocket

found out that a 1980 vw jetta steering wheel is a direct bolt-on

FabilichuS

Innstalled blue LED bulbs, and broke 3 of them cus they was to tight... Will post photos when Its dark so you guys can see how it looks
And put on "silver" bolts on the steering wheel.

lovemyp-car

Tightened a loose spark plug,
Replaced a lost nut and tightened the other two nuts on the passenger side collector flange,
reattached the exhaust to the rubber hanger,
straightened the muffler
tightened one of the shift linkage bolts that had loosened up A LOT, the shifter is so tight now, it's AWESOME!

Excelerate

I spent much of today looking for a double DIN stereo to install this summer, as well as trying to figure out the clutch problem that's been keeping me from driving. In less than 24 hours I get to go home and finally see what has been crippling my baby for the last 4 months I've been away from her!

thirdgenbird

installed foglight switch an a manual override for cooling fans. with the switch off the fans act normal, on the fans both go to max cool. it may not be needed, but my ac was completely removed and the switch was cheap.

found out that the relay that dings when the door is open is the same one that controls the seatbelt light (you can replace these bulbs too)