esonefour

Apart from one of the "Mustang owners club" going down a bank and a cyclist decided his Sunday morning workout was more important, ran smoothly.
Last SS was 15 sec time slots to get it wrapped up before 3:30.
Don't think they are doing a bambina this yea? But I could be wrong ..

996tnz

Thanks for the pics. Brings back some of the better memories of last year's event. If compressing the time slots is the worst that happened, then they are improving.

Targa Bambina 2015 is the Rotorua event starting 14 May, and a good bunch of us are looking forward to it: http://targa.co.nz/targa-bambina-2015

shiraz

"I Broke the cameraman" for anyone who has not yet seen it.

http://www.stuff.co.nz/motoring/news...che-911-gt3-rs

esonefour

Rotorua sounds like fun !
Hopefully they will leave the fresh road repairs till after or well before bambina.

mikey_audiogeek

Scott's car. Razzo built the motor. I'm sworn to secrecy on the build cost, Scott's wife doesn't know...

Cheers,
Mike

gt38088

re discussion on AF Ratios that I think John was talking about ...
Here are some pics from my readout (hidden behind a dash panel to preserve the classic look)
at idle then 2k and 3k static no load on car in neutral and clutch in, The car runs rich.
remember my car is mechanical no ECU mapping just a very expensive fuel pump

John McM

Thanks for the data points Graeme. I'm doing my research this week to see how I connect a 5 wire WB sensor to a 4 wire harness. If I get that done I could be logging my AFR on the PCNZ run on Sunday. Albeit an oil change is equally important, just have to find an oil pan that takes 10 litres otherwise I will have a very slippery garage floor.

sp1ked

I'd be terrible at that mate. Great to hear you guys had a blast. Not sure about the state it came back in :/

sp1ked

Noooo. Why would they do that Shannon?? That requires forward planning and common sense. Plus I'm certain councils think Targa drivers like gravel and pot holes ....

gt38088

haha good stuff..

Maxem

One lucky kiwi boy that Brendan fella.

Garry D

Yes Dave , and he's a Palmy boy !
His dad Brian Hartley is a very good engine builder and driver in his day .

cliffjumper

He rebuilt the motor in my girlfriend's datsun 1600/p510 about ten years ago. Still runs sweetly and reliably. He's currently building another datsun motor for a family member, which will no doubt come back far too nice for the 260c that it's out of

John McM

A slow night. Macca must still be in the dog box or using his limited time to post about the GT3RS

Just saw this about bags, but a number of us could change it into the following about cars.

"My fear is that I shall die and my wife will sell my cars for what I said I spent on them"

O2GO

Nice parking and photos :-)

Wohoo, we are in for some fun boys! PMs on the way to swap details.

John I have a 13l oil pan from SCA which you're welcome to. Pick it up on the way from the airport?