twodollardoug

I thought it was tied to the memory button and was chasing my tail like javcs. Until I finally figured it out.

javcs

I couldn't wait until tomorrow. went back down and you are correct. I placed the pig in reverse adjusted the mirror to the desire position and it work like a champ. thanks every one. I also got the wiper Teardrop function working.

twodollardoug

WHEW! I was worried that I was sending you on a wild chase.
​​

F SANE IL

Try unchecking save, shut off car, then check and save again

love2020

This shop is available for 365eur: https://www.obdexpress.co.uk/wholesa...tester-ii.html
It's okay for the older car, for new cars, advise you piwis 3 scanner.

Loulouton

As I said it is just the VCX unit. It is clearly written: « This is only hardware, no laptop and software in the package »

You can do nothing with this item only, you must add a laptop+the soft and then you have a functionnal PIWIS 2 tester

Iustin Simion

Hello everyone,

I tried to read the whole thread and didn’t find anything about the air suspension.

Could you please check if the Launch tester has any option to check the pressure in the system, re-calibrate the system, or that bleeding and fill options for example when you re-fill the nitrogen in the system, etc?

Thank you very much!

F SANE IL

I saw an entire maintenance menu for air suspension, but I'm sure noone here is brave enough to randomly test these features out unless their in a pickle.

911-997

as he mentioned, there is a menu just for air suspension and you can even test each unit but you need someone brave to test it out. I didnt want to mess with my air suspension

Iustin Simion

Thanks guys. You sold me on this tool. I’ll order one.

F SANE IL

Want to buy this pet rock now? Only $35k

twodollardoug

Jump on in, and post up. Just be careful with it.

F SANE IL

I went into x.431 and recalibrated my height values. For some reason the four shocks were at different heights. Now its all even.

I'd love to actually get the OE ride height for normal setting with 21" rims.

Side note in regard to prior discussion.....
I checked the rear lid and the only option enabled on my CS is one-touch opening from the driver door button. I tried to enable closing and it doesn't take.

Anyone got that enabled?

rainer

The ECU for rear lid opening/closing does not accept that coding for security reasons. If you try that with Piwis you get a corresponding message..

F SANE IL

So, you're saying if I do this with a PWISII, it will work or will i need some kind of security unlock?