What did you do to your 924/944 today
#436
Three Wheelin'
Got the pearl and clear coats on. It's not perfect, but it will do for a set of phonedials.
Last edited by fortysixandtwo; 01-07-2012 at 08:08 PM.
#438
Rennlist Member
touched up some rock chips, fixed the heat exchange door clip, general wash and vacuum. Also entertained an offer from a guy in the parts store parking lot..lol.
#439
i sanded down the bumpers took off those ugly pads (fs haha) and jb welded those holes and bondoed them up and sanded them back down and test fitted everything =D
[IMG][/IMG]
[IMG][/IMG]
#443
Racer
Join Date: Feb 2009
Location: Elk Grove, IL. 85.5 n/a 944
Posts: 308
Likes: 0
Received 0 Likes
on
0 Posts
David Floyd
Got a pic ?
I am filling the splits in my dash (Bondo method) and am looking for finish options, bought textured paint, just not sure yet... well, back to sanding
Just did some searching and turned up an old post using SEM Texture Coating and SEM paint over bondo, looks to be thr ticket.
-------------------------------------------------------------------------------------------
it's not oem finish. it makes the dash a uniform color and texture, that's all i wanted.
Got a pic ?
I am filling the splits in my dash (Bondo method) and am looking for finish options, bought textured paint, just not sure yet... well, back to sanding
Just did some searching and turned up an old post using SEM Texture Coating and SEM paint over bondo, looks to be thr ticket.
-------------------------------------------------------------------------------------------
it's not oem finish. it makes the dash a uniform color and texture, that's all i wanted.
#444
Replaced my front wheel bearings, receiver drier and trans oil with swepco. I think I have have only one of ten 944's in the US where the a/c, clock, sunroof all work and the dash has no cracks.
#445
Rainman
Rennlist Member
Rennlist Member
drove it from san jose to san diego yesterday on less than a tank, and the whole way questioned my oil pressure. the gauge read 2 bar the whole way and would drop to 0 and the light would come on at idling, but there was no weird noise or anything, no leaks, and the oil level was perfect.
going to clean the sender wires today, maybe put a different gauge in
going to clean the sender wires today, maybe put a different gauge in
#446
Nordschleife Master
Pulled the tranny to swap in a short 5th gear. Hopefully will have time this weekend to finish the job. I'll be watching the Rolex race tonight instead of wrenching.
#448
yesterday:
put on my Dansk muffler...the old was rotted and noisy
replaced the missing middle rubber hanger at the flange
got the tires balanced, got rid of a shimmy at 72...smooooth now
replaced my missing idle screw & adjusted
put on my Dansk muffler...the old was rotted and noisy
replaced the missing middle rubber hanger at the flange
got the tires balanced, got rid of a shimmy at 72...smooooth now
replaced my missing idle screw & adjusted
#449
Rainman
Rennlist Member
Rennlist Member
pulled the old oil sender, found out it was leaking and had loose terminals, put the original back on the car, gauge reads perfect.
pulled the power steering cooler and reservoir and sealed the lines on the rack. much easier than i thought it would be
pulled the power steering cooler and reservoir and sealed the lines on the rack. much easier than i thought it would be