What did you do to your 996TT today?
#8896
Rennlist Member
Are you sure the green ones are the original/Correct ones? Sorry if this has been mentioned before.
#8897
Rennlist Member
I think the original part was 996 106 801 04, superseded by 996 106 801 06 which are the ridged ones? Not sure if you can still get the old style.
Last edited by pfbz; 04-23-2021 at 07:50 PM.
#8898
Rennlist Member
FWIW I think the clips are 996-106-802-12.
The following 2 users liked this post by krs1skier:
diverzeusy (04-24-2021),
Rambler_13 (04-26-2021)
#8901
Advanced
#8903
Your local auto parts store has these in stock or can most likely get them the same or next day.
#8904
Rennlist Member
Replaced my dying alternator w/ new Bosch 150 amp unit (AL0815N), and replaced the belt and fuel filter.
Also replaced Pagid Yellow(F) / Black(R) pads with Endless MX72's - still a little noise after bedding in but much more tolerable for street use.
Also replaced Pagid Yellow(F) / Black(R) pads with Endless MX72's - still a little noise after bedding in but much more tolerable for street use.
#8905
Driver side of the spoiler not lifting was a known issue when purchased recently and today was nice enough to look into it. Had assumed cylinder leak but looks like I have a torn line. Hopefully that solves it. Sorry, pic didn’t seem to focus that close but rubber splits when bent.
Then met up with a buddy to test his Boxster GTS. Was a pretty fun car and nice exhaust note in sport but am still pretty damn happy about going with the 996tt.
Then met up with a buddy to test his Boxster GTS. Was a pretty fun car and nice exhaust note in sport but am still pretty damn happy about going with the 996tt.
The following users liked this post:
Rambler_13 (04-26-2021)
#8906
Rennlist Member
Finally finished modifying the **** out of my SRM Y-Pipe so I could install it.
The following 4 users liked this post by LinwoodM:
#8907
RL Community Team
Rennlist Member
Rennlist Member
Wow, that is cool and I think I want it.
I get the two blow off valves, but what have you ported in inside of the BOVs?
I get the two blow off valves, but what have you ported in inside of the BOVs?
The following users liked this post:
LinwoodM (04-26-2021)
#8909
RL Community Team
Rennlist Member
Rennlist Member
There's going to be a lot of popping and whooshing on that setup.
Water/meth nozzles make sense.
Water/meth nozzles make sense.
#8910
Burning Brakes
Driver side of the spoiler not lifting was a known issue when purchased recently and today was nice enough to look into it. Had assumed cylinder leak but looks like I have a torn line. Hopefully that solves it. Sorry, pic didn’t seem to focus that close but rubber splits when bent.