What did you do to your 996 today?
#9241
Rennlist Member
I installed some cheap external tpms senders and plugged the dongle into the cig lighter. Seen to work fine, but I'm not big on the clunky look. Next time I change tires I'll add a better internal set.
finally screwed on my new NS plate.
threw the racks back on and took the dog MTN biking. Tomorrow, I'll install a fire extinguisher, replace old 3rd brake light, and wash her, in prep for a Sunday PCA drive from Bridgewater to Liverpool. Can't be scruffy, first impressions and all that...
Post Ride. She's slobbering all over my coco mats!
New plates
😁
finally screwed on my new NS plate.
threw the racks back on and took the dog MTN biking. Tomorrow, I'll install a fire extinguisher, replace old 3rd brake light, and wash her, in prep for a Sunday PCA drive from Bridgewater to Liverpool. Can't be scruffy, first impressions and all that...
Post Ride. She's slobbering all over my coco mats!
New plates
😁
#9242
Rennlist Member
The following users liked this post:
damage98MO (09-07-2023)
#9243
Racer
The sleek, wildly expensive cup holder looks like a real scan / 3D printing opportunity for someone.
The following users liked this post:
fazm (09-09-2023)
#9244
Rennlist Member
He offers a much cheaper 3d printed version. What I like about the set up is it uses X1 cupholders. Mine is waiting at home, I'll get it installed tomorrow and post a pic.
The following users liked this post:
damage98MO (09-09-2023)
#9245
Rennlist Member
The following 3 users liked this post by fazm:
The following 9 users liked this post by 168Sierra:
binaryaudax (09-10-2023),
dcsjc (09-10-2023),
Einsteiger (09-10-2023),
fazm (09-10-2023),
peterp (09-11-2023),
and 4 others liked this post.
#9247
Racer
#9248
Rennlist Member
I have a UIDS and the engine oil sensor is in the side of the UIDS. The trans sensor will be in the drain plug. It is being fabricated now, 10 x 1 thread sensor in a custom drain plug, std drain thread with external hex drilled and tapped for 10 x 1 sensor
The following 5 users liked this post by 168Sierra:
jandackson (09-10-2023),
peterp (09-11-2023),
Porschetech3 (09-10-2023),
wdb (09-12-2023),
zbomb (09-10-2023)
#9249
Rennlist Member
The following users liked this post:
Einsteiger (09-11-2023)
#9250
#9251
Rennlist Member
I emailed that guy but he's paused production - that is a good cupholder.
I'll just have to stick with my monocle-tier etsy job
I'll just have to stick with my monocle-tier etsy job
The following 10 users liked this post by tedg04:
beermanpete (09-11-2023),
Einsteiger (09-11-2023),
fazm (09-11-2023),
JohnCA58 (09-11-2023),
maekwl (09-13-2023),
and 5 others liked this post.
#9253
The following 3 users liked this post by Jmrjimbo: