What did you do to your 996 today?
#7696
Rennlist Member
Can you recommend lift bars? I hadn't considered them, because the ones I looked at were designed for the u shaped jackstands, and I have flat top ESCO 3 tons. I've been jacking my car up by the end of the stressed member that runs side to side in front of the engine, and then placing jackstands at the jack point. I hope I'm not bending anything, sure seems ok. My low profile back just squeezes in on an angle behind the rear wheel...
Edit.... If it looks like you can get ESCO axle stand adaptors...
https://liftbars.com/ need these ...
https://www.pelicanparts.com/More_In...SVSI=TOOL&fs=0
Edit.... If it looks like you can get ESCO axle stand adaptors...
https://liftbars.com/ need these ...
https://www.pelicanparts.com/More_In...SVSI=TOOL&fs=0
Use flat tops for mid-bar as safety stop device.
Last edited by hatchetf15; 07-28-2022 at 10:15 PM.
The following users liked this post:
damage98MO (07-28-2022)
#7697
RL Community Team
Rennlist Member
Rennlist Member
I used jack stands without an problems for decades.
Then in April 2020 I have an incident and decided to buy a QuickJack.
I still own the jack stands, but use my QuckJack unless the vehicle weighs more than 5000#.
Then in April 2020 I have an incident and decided to buy a QuickJack.
I still own the jack stands, but use my QuckJack unless the vehicle weighs more than 5000#.
The following 2 users liked this post by TexSquirrel:
damage98MO (07-29-2022),
TheChunkNorris (07-29-2022)
#7698
Rennlist Member
Same but ended up with the 7k model because my Touareg is a hefty 5000lb.
The following users liked this post:
TexSquirrel (07-30-2022)
The following users liked this post:
imhighlander (07-29-2022)
#7700
Three Wheelin'
Much better.
The following 4 users liked this post by motoo344:
sasilverbullet (07-29-2022),
TexSquirrel (07-30-2022),
TheChunkNorris (07-30-2022),
wdb (07-30-2022)
#7701
Intermediate
New Esco stands with flat risers are on the way.
#7702
Racer
The following users liked this post:
peterp (07-30-2022)
The following 12 users liked this post by BReif61:
Boff (07-30-2022),
damage98MO (07-30-2022),
EVOMMM (07-29-2022),
hoofdpijn (07-30-2022),
Must_Run_Daily (07-30-2022),
and 7 others liked this post.
#7704
Three Wheelin'
Love that ducktail
The black and white contrast is awesome. Did you paint the whole car?? I need to at least respray my front bumper and around the engine lid where my ducktail is the clear is gone also. I’m trying to live with the Pitina but who knows I really like Mexico blue. I drove mine today, went to HEB got some fresh made butter tortillas and a case of Miller lite. Damn that 99 is such a blast to drive, I only went 110 today to much traffic, the silver surfer is running like a champ.
#7706
Rennlist Member
Is that a Getty Ducktail?
#7707
Rennlist Member
No sir, it is from RPMTechnik.
The following users liked this post:
GC996 (07-29-2022)
The following users liked this post:
motoo344 (08-02-2022)
#7709
Rennlist Member
Are these deep enough to work with a quick jack without using the QJ rubber blocks? That would be really handy.
#7710
Rennlist Member