Str8away Hater

I finally installed the 26.7mm front sway bar with all new bushings. I also installed the Lindsey Racing 5-way 19mm rear sway bar with new bushings and spherical drop links. This will be the first time I've driven the car with a rear bar. I have a SoloII test and tune on Sunday. I'm looking forward to flatter cornering, and running proper air pressure in the rear 255's.

Coming from a 21.5mm front bar and no rear bar, this is going to take a few driver mods!

PorscheDude1

Installed Euro Fogs and clear turn signal lenses.
I'm still waiting on my 968 mirrors and door handles to come back from paint.

I have lots of stuff to do, but can not get motivated to start because it's so damn cold.

Stuff on the list:
Install passenger side 968 door panel and infinity component speakers.
install rebuilt power steering rack, control arms, struts and Welt springs.
Swap out the dash for a nice crack free dash (old one looks like the grand canyon).
Install Sparco Steering wheel.
Replace Aux water pump.
Install Turbo S front sway bar and new bushings.
Remove old stone guards and install new ones.
Finish painting AIR Splitter and install

it sucks looking at all this pile of parts. Just need few warm days.

Project 951

Ordered personalized plates

rdanford

removed the original hood liner to install the new one...oh so much fun...

techartisan

My hands are killing me...Ive sliced every finger..smashed a few....but finally..finally my seats are pretty.

nate944

I installed a new fuel pump, two speed/reference sensors, and a cat test pipe...burned off two year old gas and got yelled at by the wife for stinking up the garage...to which I exclaimed, "this is my part of the house, isn't there laundry to do!" She smiled and asked for a ride in the car.

KLR

Put 3m 5430 squeak reduction tape around the aperture of the sunroof to see whether that will eliminate the occasional creak I get from the sunroof going over low speed bumps, speed bumps, driveways, etc.

Tom M'Guinn

I changed both of the weatherstrip seals a few weeks back and that seemed to eliminate the creaking.

Mark-87-951

Worked on pulling the turbo to fix oil leaks. Soaking the downpipe nuts in PB Blaster overnight and had to get a 15mm wrench so that I can finish tomorrow.

J1NX3D

im going to the same front bar as you and an S2 19mm bar from a 20mm front and no rear bar so i'm looking forward to the difference too!

rosco

Removed transmission to find whats broken. RIP to a differential maybe.

PorscheDude1

Finished painting the splitter this morning.

924sV8

Techartisan;
Nice seats,
How did you do it? Where did you get the materials? and How much did it cost?
Thanks

PorscheDude1

Started my dash swap.
Pulled the old dash out in 2.5 hours. Very straight forward.
I'm a little cold now. It's only 42 in the garage today:-)
hopefully I can get the new one in sometime tomarrow.

KLR

Already tried that, unfortunately. Didn't have much impact, but it's got to be something to do with sunroof seals because it never creaks when the roof is tilted open.

Today I replaced some hardware underhood with freshly re-zinc'd replacements (thanks JoshB). Also put on a new driver side seatbelt buckle and figured out that the short e-brake cable is broken.