Breakaway944

I think the loctite is for the 4 studs when installing. I will double check my manual when I get home

ste1999

Thanks so much I’d appreciate if yo can confirm that, maybe the torque spec page is unclear. Makes no sense to me to use 270 there. Surely red Loctite if you used anything at all. I’m about to finish the pump installation as it needs to be done before I can start building up the belt components, I’ll wait a bit I think. I left the studs in place as original as they didn’t look corroded and I figured getting them out would be potentially damaging, lesser of the evils and all that. Thanks for the input so far

Steve

Breakaway944

I have the same "instructions" in the beginning of my manual (but with 8(6) torque specs). However if you go the the installation page-


This is from 19-4 and 19-6, note no special instructions to use loctite on part #17 and #15
I removed my studs and I can confirm the studs have a LOT of red loctite on them. The amount of heat needed to remove bolts or studs, with red loctite, in a giant aluminum heat sink is incredible. Do not use it on the bolts!

ste1999

Thanks it does look as if the torque spec page is badly written! (studs only) or two separate lines for bolts and studs would have clarified better...

Steve

JRP944

Replaced my steering shaft with a Rennbay unit. Now the car tracks completely straight and the wobble at 80 MPH is gone!

Justin

shortyboy

Installed SFR intake manifold, intercooler pipes and turbo inlet pipe.

RZwetzig

How do you like your GTP Headlights? Thank you!

RZwetzig

How do you like your GTP Headlights? Thank you!

jhowell371

Put the sunroof in the S2 for the winter

UK_in_NY

Cleaned the sunroof drains.
Began sanding down the roof to remove the dead clearcoat
Ordered timing belt kit and new waterpump

Sat in it and imagined what it drives like. (new project)

shortyboy

Ive had a few over the years, GT-Racing, Custom made ( a member here ) and these GTP. By far the best fit, finish and quality. Theyre vented also.

V2Rocket

how's the light output on the road?

FrontPorsche87

I am doing the K & N air filter in my 87 944 N/A this afternoon.
Just picked it up after special order at Autozone.
I am very happy that it is washable and reusable at $70

FrontPorsche87

I need to do the instrument lamps as well, very dim on my 87 944 N/A. Otherwise interior nearly perfect
Can the be replace from underneath ?

doolittle

Installed custom designed stone guards I had Van make for me. I tried to go with a 911 flavor, rather that the squared off 924 Carrera GTS style.