When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Put new PORSCHE decal above rear bumper... Started replacement of all the gauge/instrument panel bulbs (some old ones burned out). Going 100% LED - interior and exterior (turn signals, etc.)
Today I got the urge for a little time travel. Since my 84 resides in the man-cave with me I walked over and lifted the cover, opened the door and smelled 1984 with all it's good memories. Closed the door, dropped the cover and returned to 2019 until next time. Sadly the S2 shivers in the outside garage at 25 degrees this morning but Spring is just around the corner
Replaced camshaft & balance belts. First belt replacement for me and it was not difficult. Big thanks to Clarks Garage and Arnnworx tools; I could not have done without them. Also changed the clutch slave and master cylinders and both soft lines and the oil & filter with Mobil1 15W-50. Now she's ready for another year of not-so-much driving.
Today I got the urge for a little time travel. Since my 84 resides in the man-cave with me I walked over and lifted the cover, opened the door and smelled 1984 with all it's good memories. Closed the door, dropped the cover and returned to 2019 until next time. Sadly the S2 shivers in the outside garage at 25 degrees this morning but Spring is just around the corner
Ugh
Son came over yesterday to help with putting in new axles & CV’s. Had one bolt almost not make it out (stripped head). Then went to one of the new axles with CV’s attached and one the race is jammed, binding badly and one if the bearings out and deep in the boot.
Sigh
Replace today then install
What should’ve been a two hour job spent almost 5 on
I live in the UK - Inherited LHD 944s 1988 non runner - had no keys for it - and i have no clue (Novice) what i'm doing or getting into!!!!!!
Jobs completed this weekend -
charge battery - COMPLETED
My first job - replace drivers side door lock - COMPLETED
2nd job replace ignition lock - removed dash trim etc - drilled out old shear nuts - replaced with new 2nd hand one and tested - COMPLETED
Get into the boot/truck and check for leaks - found the carpet was wet - removed carpet and now is drying - COMPLETED removal of dash removal of dash before drilling replacement ignition installed new ignition
net lot of jobs -
drain and replace fuel (approx 7 years old!)
inspect cam belts etc before i decide to turn it over
Replacing my original 31 year old 80k mile shocks on my 88 924SE. Used my old ones as a test run using the procedure :
https://rennlist.com/forums/944-turbo-and-turbo-s-forum/513387-adjusting-new-koni-rear-yellows.htm
I found my new ones have less adjustment turns... 31 year Old vs new 8040 sports