What did you do to your 924/944 today
#9092
Instructor
Steve
#9093
Rennlist Member
I have the same "instructions" in the beginning of my manual (but with 8(6) torque specs). However if you go the the installation page-
This is from 19-4 and 19-6, note no special instructions to use loctite on part #17 and #15
I removed my studs and I can confirm the studs have a LOT of red loctite on them. The amount of heat needed to remove bolts or studs, with red loctite, in a giant aluminum heat sink is incredible. Do not use it on the bolts!
This is from 19-4 and 19-6, note no special instructions to use loctite on part #17 and #15
I removed my studs and I can confirm the studs have a LOT of red loctite on them. The amount of heat needed to remove bolts or studs, with red loctite, in a giant aluminum heat sink is incredible. Do not use it on the bolts!
#9094
Instructor
I have the same "instructions" in the beginning of my manual (but with 8(6) torque specs). However if you go the the installation page-
This is from 19-4 and 19-6, note no special instructions to use loctite on part #17 and #15
I removed my studs and I can confirm the studs have a LOT of red loctite on them. The amount of heat needed to remove bolts or studs, with red loctite, in a giant aluminum heat sink is incredible. Do not use it on the bolts!
This is from 19-4 and 19-6, note no special instructions to use loctite on part #17 and #15
I removed my studs and I can confirm the studs have a LOT of red loctite on them. The amount of heat needed to remove bolts or studs, with red loctite, in a giant aluminum heat sink is incredible. Do not use it on the bolts!
Steve
#9095
Rennlist Member
Replaced my steering shaft with a Rennbay unit. Now the car tracks completely straight and the wobble at 80 MPH is gone!
Justin
Justin
The following 2 users liked this post by shortyboy:
Jay Wellwood (12-02-2019),
phL (11-13-2019)
#9100
Intermediate
Cleaned the sunroof drains.
Began sanding down the roof to remove the dead clearcoat
Ordered timing belt kit and new waterpump
Sat in it and imagined what it drives like. (new project)
Began sanding down the roof to remove the dead clearcoat
Ordered timing belt kit and new waterpump
Sat in it and imagined what it drives like. (new project)
#9101
Rennlist Member
The following 3 users liked this post by doolittle: