What did you do to your 996TT today?
#5116
Drifting
#5117
RL Community Team
Rennlist Member
Rennlist Member
#5118
Drifting
#5119
RL Community Team
Rennlist Member
Rennlist Member
#5120
Drifting
yah thats what we did but with a shot of 303, i was worried that we didnt fit the intake on correctly because it was moving a bit but it its holding boost in 4th and 5th.
#5121
Three Wheelin'
Keep 303 or anything else that contains silicone away from your intake and exhaust. The silicone can foul O2 sensors. To get my Y pipe in there i just make sure the clamp is really loose, then push it in with both hands one on the right pipe and one one the left with a slight rocking motion and it pops in. it does need "significant " pressure however and you need to make sure the large vacuum tube and the MAP sensor connector are not getting in the way.
#5122
Haha yep me and a buddy got it out after an hour or so of figuring out there was a 10mm on top of the intake. Then i added another hour or so because i snapped the bracket holding the thing to the chassis. Next up fuel pump *** and venturi lines! Then maybe power steering. I couldnr get the rubber y pipe back onto the intake straight and just left it cocked a bit, there a trick to getting that thing sleeved correctly?
#5123
Drifting
Keep 303 or anything else that contains silicone away from your intake and exhaust. The silicone can foul O2 sensors. To get my Y pipe in there i just make sure the clamp is really loose, then push it in with both hands one on the right pipe and one one the left with a slight rocking motion and it pops in. it does need "significant " pressure however and you need to make sure the large vacuum tube and the MAP sensor connector are not getting in the way.
#5127
Burning Brakes
Kevin would be the one to respond, but I did a pressure test at the intake and immediately heard the air loss coming from the passenger side actuator. The internal membrane is shot. I was just going to buy a replacement but balked at the Porsche price for a single unit. Started hunting around for an alternative and Kevin suggested I send them up to him for a rebuild and spring upgrade. The spring upgrade is supposed to work nicely with my otherwise stock X50.
#5130
RL Community Team
Rennlist Member
Rennlist Member
Now that is sexy...