What did you do to your 924/944 today
06-18-2012, 10:56 PM
#4146
whb944s and andys-944 Glad you guys are both okay. I'm sure you're both pretty distraught. 
If somehow people understood how much goes into these cars they'd be more careful. Morons.
But, glad you're both okay.
I don't think Cookie Cutters ever came in 15x8. Fuchs did, you have the correct sizes for a 944 delivered with Fuchs. Cookies I'm pretty sure only came in 15x6 and 15x7. The 944 got 7's all around.
Take care!
If somehow people understood how much goes into these cars they'd be more careful. Morons.
But, glad you're both okay.
Take care!
06-19-2012, 12:27 AM
#4148
7th Gear
Join Date: Jun 2012
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
--------------------------------------------------------------------------------
Da'ym, thats some elevation change. standing on turn one looking at the start? would have been sooo much fun if that was the last turn heading for the finish!....
They can lay a lot of pavement in pretty short order, but thats not building confidence in November...
__________________
Da'ym, thats some elevation change. standing on turn one looking at the start? would have been sooo much fun if that was the last turn heading for the finish!....
They can lay a lot of pavement in pretty short order, but thats not building confidence in November...
__________________
06-19-2012, 04:06 AM
#4149
Three Wheelin'
Test-fitted my old IC setup to the 951 nosed 924 CGT.
Replaced the id plate holders.
Bought a POP-OFF valve since my K27/K26 hybrid does not have one.
Did some measurements and realised that i have to lower the rear right corner by 10mm. i'll try do get this done from the eccentrics.
Replaced the id plate holders.
Bought a POP-OFF valve since my K27/K26 hybrid does not have one.
Did some measurements and realised that i have to lower the rear right corner by 10mm. i'll try do get this done from the eccentrics.
06-19-2012, 04:43 AM
#4150
Professional Hoon
Rennlist Member
Rennlist Member
Join Date: Jan 2010
Location: Melbourne, Australia
Posts: 7,090
Likes: 0
Received 4 Likes
on
4 Posts
So I finished the project, and now must scrap it after 10 hours work 
it looks pretty cool too
If you're wondering, it was made out of two small plastic storage tubs
The box I made was rubbing on the serpentine belt when I went over bumps
Time to do it right and buy a stock airbox k&n and use the aluminum ducting from stock box down to fender... Ug.
it looks pretty cool too If you're wondering, it was made out of two small plastic storage tubs
The box I made was rubbing on the serpentine belt when I went over bumps
Time to do it right and buy a stock airbox k&n and use the aluminum ducting from stock box down to fender... Ug.
the white is any tube you can get your hands on.
the blue is any plastic/aluminium/fiberglass that you can get your hands on.
red is a cone filter.
I think it's pretty understandable the picture i drew in 10 seconds.
06-19-2012, 07:46 AM
#4151
Three Wheelin'
