When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Odd, mine were 3M tape and the black high grade caulking for the seams. Where did you get yours from? I used Top End Motorsports.
I got mine straight from the manufacturer in Germany so that might be why the supplied adhesive differs. 3M tape would make the installation a lot easier.
Much easier with bumper off. Water pump and tandem oil pump are difficult with bumper and engine plate. To be honest having your engine hanging in the wind while you work is a bit stressful but I took my time and used extreme caution. I also worked over the course of several weeks.
Easier with the bumper off? Looks like you had great access.
For sure easier with the bumper off. Did fresh plugs, coil packs, water-pump, belt as preventative maintenance. Bumper had to come off to get to a few of the pesky fasteners and headers had to come off for just a couple of the plugs (dang it), so, fresh ceramic coating on the new Soul headers (thanks Brian!). Mounted fresh Girodisc 350mm replacement rings with Pagid 29's all around, fresh gear-side oil and fresh DCT for the PDK. Generally. getting her ready for the season opener for me at Road Atlanta PCA 3 day event April 8-10. Hope to see some of you there.
I'm doing mine this weekend, also tranny oil, hoping for some improvement.
Going to check the shift cable adjustment as well.
New motor mounts last weekend.
I don't think you can say "tranny oil" anymore... :-)