My 964 C2 Transformation Build Thread
#811
Basic Sponsor
Rennlist
Site Sponsor
Rennlist
Site Sponsor
Here are a few beauty shots of our BBi Autosport Billet Uprights installed on Chris' car
__________________
Bringing Passion, Artistry, Craft to the Porsche Tuning Industry
Southern California's Porsche Performance Tuning, Engine Development,
ECU Software Tuning, Custom Fabrication, Race Preparation & Factory Service Center
Website: www.bbiautosport.com Email: sales@bbiautosport.com Phone: (714) 843-0200
Follow Us On: Facebook & Instagram
Bringing Passion, Artistry, Craft to the Porsche Tuning Industry
Southern California's Porsche Performance Tuning, Engine Development,
ECU Software Tuning, Custom Fabrication, Race Preparation & Factory Service Center
Website: www.bbiautosport.com Email: sales@bbiautosport.com Phone: (714) 843-0200
Follow Us On: Facebook & Instagram
#812
Rennlist Member
Thread Starter
Update:
motor work done
trans work done (GT Diff, and goodies!)
motor ready to go back in
finishing up carpets
so:
glass back in
install rest of interior bits
install motor
finish exhaust fab
finish electric PS fab
align
Then it goes up north for a few other goodies :-)
ITS CLOSE
motor work done
trans work done (GT Diff, and goodies!)
motor ready to go back in
finishing up carpets
so:
glass back in
install rest of interior bits
install motor
finish exhaust fab
finish electric PS fab
align
Then it goes up north for a few other goodies :-)
ITS CLOSE
#813
Pro
Update:
motor work done
trans work done (GT Diff, and goodies!)
motor ready to go back in
finishing up carpets
so:
glass back in
install rest of interior bits
install motor
finish exhaust fab
finish electric PS fab
align
Then it goes up north for a few other goodies :-)
ITS CLOSE
motor work done
trans work done (GT Diff, and goodies!)
motor ready to go back in
finishing up carpets
so:
glass back in
install rest of interior bits
install motor
finish exhaust fab
finish electric PS fab
align
Then it goes up north for a few other goodies :-)
ITS CLOSE
#814
Update:
motor work done
trans work done (GT Diff, and goodies!)
motor ready to go back in
finishing up carpets
so:
glass back in
install rest of interior bits
install motor
finish exhaust fab
finish electric PS fab
align
Then it goes up north for a few other goodies :-)
ITS CLOSE
motor work done
trans work done (GT Diff, and goodies!)
motor ready to go back in
finishing up carpets
so:
glass back in
install rest of interior bits
install motor
finish exhaust fab
finish electric PS fab
align
Then it goes up north for a few other goodies :-)
ITS CLOSE
#815
Rennlist Member
Thread Starter
I’ll get pics when done. It’s simple:
991turbo s muffler. 2 in 2 out. Very similar to gt3 design but side vs center exits
cut shorter in width to fit
rothsport 1 3/4 primary headers
exit headers into center.
Dual exit sides
custom Heat boxes
991turbo s muffler. 2 in 2 out. Very similar to gt3 design but side vs center exits
cut shorter in width to fit
rothsport 1 3/4 primary headers
exit headers into center.
Dual exit sides
custom Heat boxes
#817
Rennlist Member
Thread Starter
#818
Rennlist Member
Thread Starter
Motor is ready to go in. Had to fix a fuel line where rubber was failing.
Left to do:
install motor and trans
finish last bits of interior
install glass
fab exhaust
finish ps install
align
tune
Left to do:
install motor and trans
finish last bits of interior
install glass
fab exhaust
finish ps install
align
tune
#820
Rennlist Member
Thread Starter
Thanks, getting there.
Fab should start this week, going to wire up some basic heat boxes that will hide some of the header goodness, but I like a little heat. Can be chilly by the beach in the AM. I know BBI has also used a 991.2 setup before on these. Just depends what you want. The factor mufflers aren't all that expensive, then you need to mod a bit.
This will be about 1/5 the price, before engine build LOL :-) Singers are too fancy for me. I prefer rainbow flip flops over ferragamo
This will be about 1/5 the price, before engine build LOL :-) Singers are too fancy for me. I prefer rainbow flip flops over ferragamo
#821
Rennlist Member
Thread Starter
This is trip #1 of parts lol
#823
Rennlist Member
Thread Starter
#824
Three Wheelin'
Hey man any reason why you didnt do the lexan 1/4 and rear window?
or maybe you did and I missed it?
or maybe you did and I missed it?
#825
Rennlist Member
Thread Starter