3 Liter Turbo Registry
#601
Rennlist Member
Thread Starter
I measured mine at 33cc. I have no idea what head Andial had in mind when they decided to market these as 8:1 pistons, but with an '89 2.7 head they come out over 8:5:1.
#603
you know my Pistonstyle from the other board ..... there is 32,5 - 32,8 cm³
Head : 65,0 -65,2 cm³
but i think ya wanna know the high from the ground of the bowl till piston top right??
greetz urs
#607
Rennlist Member
Thread Starter
Thom, I will pull a piston out and measure this week. Meant to yesterday but ran out of time.
In the meantime, I have a question for you 3L folks. I've noticed that my timing belt runs very far forward on my cam gear -- actually hanging off the front of the gear by half a mm or so. I have my theories but curious if anyone is seeing this on their 3 liter motor -- particularly those with 89 8v heads...?
In the meantime, I have a question for you 3L folks. I've noticed that my timing belt runs very far forward on my cam gear -- actually hanging off the front of the gear by half a mm or so. I have my theories but curious if anyone is seeing this on their 3 liter motor -- particularly those with 89 8v heads...?
#612
Rennlist Member
Thread Starter
#614
Rennlist Member
Tom,
Can you add me to the list as my car is now running?
Refresh951, 2.85L Blown944 custom stroker, JE, Eagle, sleeved & filled, TO4E DBB 50 Trim, #8 Hotside, Rogue Tune
Can you add me to the list as my car is now running?
Refresh951, 2.85L Blown944 custom stroker, JE, Eagle, sleeved & filled, TO4E DBB 50 Trim, #8 Hotside, Rogue Tune
#615
Rennlist Member
Thread Starter