What did you do to your 924/944 today
#2461
Nordschleife Master
#2462
Instructor
It's pretty much Lamin-X. Tinted vinyl. I did a horrible job installing it honestly as I didn't have a heat gun to make it stretchy. I've got enough to do it again but I'll take my time haha.
#2463
Rainman
Rennlist Member
Rennlist Member
Yesterday, dirving home, took a curve fast, picked up speed and shifted from third to fourth.....well tried to shift from third to fourth. Stuck in third. Stop at gas station, get out gerber, disassemble center cosole partly. That dang little c-clip had gone on vacation. Got some wire from the back, did a temp fix, back on the road in 5 min. Removed dang little c-clap from parts car last night, got to put the console back together but no worse for the experience.
michael
michael
#2465
Pro
took my power steering pump appart found out the snap ring on the end of the shaft had fallen off ? and some how it came off the spline >.< so i had fun putting all the vains back in place tested it out works good. not sure why the snap ring came off the shaft so... who knows how long the pump will last >.< also installed some licence plate holders
#2467
Racer
Join Date: Feb 2009
Location: Elk Grove, IL. 85.5 n/a 944
Posts: 308
Likes: 0
Received 0 Likes
on
0 Posts
#2468
Rennlist Member
Got my car prepped for the DE season - new tires and fluids, including new gear oil, brake fluid, and motor oil. On April 2nd, I'll be traveling up to Lime Rock for the first DE of my 2011 season - I can't wait!
#2469
Began Cleaning the 968 intake... got a question...
Today, I started the process of cleaning up the 968 manifold I got off eBay last week. I want to clean it inside and out and the easiest way to clean the inside would be to remove the two plugs that are screwed into the manifold... anyone know how to get those out? Is there a special tool that Porsche didn't tell anyone about?
Last edited by MacinTek; 06-17-2013 at 03:03 PM.
#2471
Rainman
Rennlist Member
Rennlist Member
definitely hot tank, i wouldn't mess with the plug.
or put some gas in it and plug the ports and swish it around a bit, then repeat with degreaser, then repeat with dishsoap/water
oh hey you're in fallbrook...im in poway/riverside
or put some gas in it and plug the ports and swish it around a bit, then repeat with degreaser, then repeat with dishsoap/water
oh hey you're in fallbrook...im in poway/riverside
Last edited by V2Rocket; 03-26-2011 at 10:49 PM.
#2472
Addict
Rennlist Member
Rennlist Member
#2473
Kewel.... know anyone with a hot tank and the proper solution in North San Diego County?
#2474
Rainman
Rennlist Member
Rennlist Member
i always just drop it off at a machine shop in poway, its $20 to hot tank something. parts coming back looking new. there should be a shop closer to you, maybe in escondido, that can do it. just tell them to use aluminum-safe solution
#2475
How about yellow zinc plating for the other parts? Any recommendations?