What did you do to your 997 today?
#5251
Rennlist Member
#5252
Addict
Lifetime Rennlist
Member
Lifetime Rennlist
Member
Replaced my Function First shift right kit, the rear metal part snap ring wasn't staying. FF sent me a new part.
Swapped out my glovebox for a leather one as it was the one part I was missing. Have now installed all the leather parts in the full leather package except for the dash. Would like to add the center console.
Swapped out my glovebox for a leather one as it was the one part I was missing. Have now installed all the leather parts in the full leather package except for the dash. Would like to add the center console.
#5253
Replaced the passenger window switch, door handle sensor, and latch assemble in an attempt to make the window behave.
And an oil change.
And an oil change.
#5254
Burning Brakes
Replaced my broken frunk switch using this thread to help: https://rennlist.com/forums/997-foru...f-plate-5.html
Washed it and vacuumed the inside- rain is done for a while here in CA
Next week oil change and probably new rocker panels
Washed it and vacuumed the inside- rain is done for a while here in CA
Next week oil change and probably new rocker panels
#5255
Racer
Pulled mine out of storage for a wash before attending today's cars & coffee type event at our car condo. It was 75 degrees today, which is unusually warm for February for us, so turnout was huge!
Coolest car at the meet
Our 3 Germans
Coolest car at the meet
Our 3 Germans
#5256
Addict
Lifetime Rennlist
Member
Lifetime Rennlist
Member
Took the long way to Cold Spring Tavern on Stagecoach in the San Marcos Pass. 101 -> 33 ->150->192-->154. Afterwards went down to Santa Barbara for dinner, then blasted back up the 101 home. A nice little 185 mile run to remind me of the good old days when I was the "Tour Guide" for the "Hey Wait For Me Racing" group "fun runs."
#5257
Rennlist Member
Over 600 cars at the the fourth annual Concours in the Hills auto show at Fountain Park in Fountain Hills, Arizona. Charity Event for the Boys & Girls Club; which last year raised a total of $ 90K. We only had some 40 Porsches this year as there was also a PCA HPDE event. It was Great Day!
#5259
Drifting
I normally run all the Club autocrosses but I had a conflict with the schedule so I did not register. Well, my conflict was cancelled so I attended as a volunteer and helped with the car lineup and grids, keeping gas in the small generator, telling drivers how many cones they ran hit and having a great time. Thirty drivers, in two run groups, from the PCA Longhorn Chapter ran a challenging course - as usual - set up by Jack Merrell. Here's a photo of part of the line up.
#5260
That looks great but will it scrape? You car looks pretty lowered and that lip sticks out quite a lot. I just installed my GT3Tek front lip spoiler and my 997.2 is sitting on Sharkwerks lowering springs and the lips are scraping more than I anticipated!
[QUOTE=dbokman;13950134]Installed aerokit front bumper and gt smiley.
[QUOTE=dbokman;13950134]Installed aerokit front bumper and gt smiley.
Last edited by Terrytwn; 02-14-2017 at 02:44 AM. Reason: took out the other images and kept one to keep my message smaller
#5261
[QUOTE=Terrytwn;13957361]That looks great but will it scrape? You car looks pretty lowered and that lip sticks out quite a lot. I just installed my GT3Tek front lip spoiler and my 997.2 is sitting on Sharkwerks lowering springs and the lips are scraping more than I anticipated!
I have H&R springs with the factory PASM for suspension but yes you have to be a little more careful pulling into driveways and such but knock on wood i have yet to scrape it... On a flat surface I have 4" from floor to bottom of lip spoiler.
I have H&R springs with the factory PASM for suspension but yes you have to be a little more careful pulling into driveways and such but knock on wood i have yet to scrape it... On a flat surface I have 4" from floor to bottom of lip spoiler.
#5264
Rennlist Member
Off to lunch, top down in SoCal spring like day. Ordered wheel spacers. 7mm F 15mm rears. Stock wheels 997 base.