When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Finally got her back from the shop with a few upgrades
Deep dish Tramont Cup2’s - extremely fast turn around from Christine too. Totally in love with them. Special call out to P-Daddy and Sander97c2 for their advice and info on specs!
RS side skirts
Rennline rear refreshed suspension, all control arms
Turbo S ducts from a Rennlister
and a DAS roll bar 😁
Glue failed on my sunroof headliner (sagging) so removed it and re-glued. Spent a lot of time with a heat gun and stretching it, using clips along the way until it was taut by the perimeter. Glued perimeter then pulled center through and glued it. Kept center in place with magnets.
Since much of what I'm doing is based around my intentions of doing a paint correction I started with the sunroof panel I removed. Wet sanded with 1000 and a soft block. Since I had no finer paper on hand, compounded that out which was easier than I thought but still rather time consuming. Probably because it's single stage.
Installed these beautifully done seats from lart951. Opted for matching black leather with red stitching to complement the red/black Coco mats. Easy bolt-in & plug-in installation, and they look great, feel great...very supportive. Thank you, Lart!
Looks great! Can you tell me more about these seats and inserts? Recaro?
@Cadaver -- Yep, Recaro Pole Positions in (p)leather. Inserts were custom by P1 Designs out of Texas. I think the pattern was dark gray and gray houndstooth.