991 GT2/3RS strakes on GT3...
The following users liked this post:
RDCR (07-13-2022)
#47
Rennlist Member
Yes you can install all the parts on .1 as well, anyway you need to add all the additional fastener points in the underbody panels and wheel arches, since the .1 don.t have any strakes from factory.
The following users liked this post:
RDCR (07-13-2022)
#49
#50
Rennlist Member
Thread Starter
I really think I want to go with OEM from the 2RS (or 4RS) vs drilling & cutting for the 992 ...
Last edited by Larry Cable; 07-16-2022 at 04:36 PM.
#53
Rennlist Member
Thread Starter
what we need to do is figure out the p/#'s for the 2RS parts ... and get a set ...
I now wonder if the 4RS strakes will also fit a 718 Spyder
Last edited by Larry Cable; 07-17-2022 at 02:20 PM.
#54
Last edited by bishwei; 07-17-2022 at 06:48 PM.
#55
Rennlist Member
Thread Starter
#56
Rennlist Member
As shown in post #24 of the thread. 991.2 GT3, GT3RS, and GT2RS all have the same single piece strake on the under body.
what we need is the 2 piece strakes from the GT4RS for most likely a direct bolt-on solution.
what we need is the 2 piece strakes from the GT4RS for most likely a direct bolt-on solution.
#57
Instructor
I tracked the 4rs strakes down a bit more, and it seems they originated from the gt2rs clubsport car, as shown
#58
Rennlist Member
Thread Starter
Ive ordered a set of the 4RS strakes - watch this space
The following users liked this post:
Diego7K (07-19-2022)
#59
Rennlist Member
I tracked the 4rs strakes down a bit more, and it seems they originated from the gt2rs clubsport car, as shown https://youtu.be/GckaseyXhkE?t=1187
Same here, they also cost about 1/3 of the 992 ones.
The following users liked this post:
Larry Cable (09-13-2022)