davek9

Your most welcome Erick, had fun working w/ my son and getting it all done.

Here a few pic's Greg's new Drive Shaft, very nice
Old bearings pushed out, only one of the three felt smooth..

w/ the new Drive shaft and The Black Sea Super bearings, can't wait!

davek9

Yesterday I removed the CE in my Gold 86.5 (the Onion) and it lived up to it's name, another layer removed and more stink

I'll be replacing that front wiring harness next as I did w/the rear one, I have no idea what under all that tape but do see melted wires going into it.

Anyone know what that silver box below the Leaking Heater core is
Edit: per grid locator it's the Cruse Control

Thank you,

Dave

zekgb

Found and fixed the broken vacuum hose at the tranny bellhousing. Now I don't get whiplash on upshifts any more.

atari_st

I just walked out to the shop and looked at it. Currently restoring a 79 euro. I plan to start a thread soon of the build....just want to here it run before i start the thread.

Hilton

I watched my 87 5spd leave the driveway and disappear from view.. I'm doing school duty as my wife's on a training course all day, so she took a 928

Tazzieman

Installed Hans' front speakers ; very pleased with the result to add to the Blaupunkt Toronto & sub install recently. You can get a lot of sound for not much money these days.

conate

Replaced front fuel line and ATF cooler lines. No more ATF drips in garage. Used ATF line kit from Roger. Bought the crimping tool too, its available for loan if anyone needs it. Worked great, much better than regular hose clamps. Replaced hood shocks. No more random hood drops on head.

Andy Kay

Got it back from paint & body - hood was re-cleared
Ordered the skid plates from Carl at 928 Motorsports
Got on Sean's Calendar for transmission mounts

Jetdriver69

Found the source of a very annoying but minor coolant leak. It was a pin hole in the lower radiator hose caused by rubbing on the PS belt.

I fixed the rubbing problem with a strap rigged below the new 928 Motorsports aluminum rad, but the hose finally started to leak through the weak point.

Roger already sent me a hose, hopefully it shows up today.

yardpro

i reinstalled my hvac head after led conversion.

i also drove it for about 100 miles

GJB928

Got my front end parts back from the powder coater. I was changing out my aluminium ball joints and one thing led to another...

Steering rack
Tie rods
Wheel bearings
Brake calipers
Sway bar bushings
Power steering hoses
Clutch slave cylinder

Jetdriver69

The lower rad hose did arrive today from Roger, so I know what I will be doing tomorrow.....

the flyin' scotsman

the GTS s up in the air for clutch and TT r&r

Captain_Slow

Hooked up the battery tender and fired up the kerosene heater in the garage. Down to 9 (F) degrees last night, expecting 3 degrees tonight. Will put the car up on stands. This time it's new trans mounts and replacing the water bridge gaskets, thermostat, and oil filler neck gasket. Probably will just keep going and replace cam cover gaskets and all the associated little circular rubber bits (have the full kit).

The Forgotten On

Bought some new tires for the rear. I hope these 265's are better than the last set.