F40LM

Received my converted DME and new MAF from Josh yesterday. Looks great and can't wait to try it out.

Michael

Justin S2

I'm surprised more people haven't bumped this with updates.

Have you sold a lot of these units Josh? Can't wait for an S2 version.

Cochezz

Looking for some feed back from the early takers?

Butters944

Don't have enough moolah to afford this

Chunkerz

I can give some feedback in 24 days.

Has this been tested with the custom cam yet?

Fara

I'll do some detailed feedback, but it's going to take a while.
In the middle of a very slow rebuild at the moment -.-

dillon410021

I ordered the mtune earlier this week though i have to put my motor together and install it before i can reflect and compare it to my other 951 with autothority chips and MAF.

Rogue_Ant

Great! Looking forward to the feedback.

Justin - the reason that more people haven't bumped this, is some that are running it are my pre-release testers, so they won't post unless I ask.

Additionally, I was a bit slow getting out the first round...

No - I am a bit busy at the moment, the next chance I have to go back to the dyno will be in ~3 weeks.

F40LM

Got it installed tonight. The red wire is hooked up in 'temp' mode for now. I will be putting the car through about 130 miles tomorrow and will start a thread to post my impressions probably by the end of the week. Hope to install the offset key next when i do the water pump and rollers replacement.

Michael

goatfarmerdave

Will be ordering kit in 14 days.Have to move car to new house in 12 days.Then send Josh my dme to convert to 28 pin.I am looking forward to the gains!!!!Cheapest hp and torque mod of all times for the 944 crowd!

Cheers

AlphaOmegaPower

.............gonna get flamed.......Now all we need is a stroker N/A engine with Rogue Tune stuff to see what we can get. Using the same principles as Sid's Stroker but using higher compression pistons....I think it would be nice

Giantviper

F40LM - I am looking forward to reading your review on it.

F40LM

Have done about 80 miles with it so far but over half of that was interstate. I plan to take the scenic route home and let it stretch it's legs on a couple of cury back country roads this afternoon.

Don't want to jump the gun too soon, and while I do have a couple of questions for Josh my initial impression of the NA-Tune is this:



I will be creating another thread soon in order to really document my thoughts don't want to clog this one up with my ramblings.

michael

Nashio

How long is the turn around for sending in a dme to be converted? Not including time for shipping. Trying to figure out which month I am going to do this.

Reimu

I have some spare cam offset keys..