Cargraphic valve control unit
#286
Basic Sponsor
Rennlist
Site Sponsor
Rennlist
Site Sponsor
My apologies, I clicked in via an email thinking this was the 992 thread. We'll take a look at the 718 shortly and see if we can come up with a similar solution!
__________________
Flat 6 Motorsports
Porsche Aftermarket Specialists
www.flat6motorsports.com
Instagram / Facebook / YouTube
Flat 6 Motorsports
Porsche Aftermarket Specialists
www.flat6motorsports.com
Instagram / Facebook / YouTube
The following 3 users liked this post by Flat6Motorsports:
#287
Rennlist Member
I programmed the 2 button remote to my Homelink buttons but they only seem to work about 20% of the time… any idea why?
#288
RL Community Team
Rennlist Member
Rennlist Member
I plan to move the CG box to a location where I can get its antenna a clearer shot from the Homelink antenna, possibly feed it through the firewall where the sound symposer opening is and into the passenger compartment.
#289
Rennlist Member
Mine would for the most part work but every now and then it wouldn't the 1st try and push of the button on the overhead console.
I had other work being done so Nick (Shop-Foreman) said he would take a closer look at current location and see if he felt like there was a better location ???
Below are some images Nick took as he relocated it and after he did the New Location it does work 1st Time every-time !!!
This is where Nick originally installed the Cargraphics valve-controller below.
Below is the Original 1st install LINK.
08-01-2022, 01:12 PM
Cargraphics Mode 2 valve controller, BMC Performance intake filters, SOUL OAP install
https://rennlist.com/forums/718-gts-...l#post18279624
Read Nick's comment on Relocating the Cargraphics vale-controller at the bottom of invoice.
12-08-2023, 07:35 AM
2nd year service report below and this Post includes images that Nick sent me of ...............
Relocating the Cargraphics "Valve-Controller" to a different location and it works PERFECT after the Relocation !!!
Simply roll the page down to see the Relocation-Images of the Cargraphics "Valve-Controller".
https://rennlist.com/forums/718-gts-...l#post19154834
Hope the above helps with your Reception issues,
Terry
#290
RL Community Team
Rennlist Member
Rennlist Member
Terry, my CG controller is in about the same location, outside of the engine compartment and along that side, a little ahead of where you show the wire... reception is still not all that good for me. (Spyder)
#292
Rennlist Member
#293
#294
Here's where I put mine, but haven't setup the homelink buttons yet.