718 GT4RS
#6466
Anyway, it should cost a lot of $$$$$ so pretty sure I will keep it simple as in previous cars
#6467
#6468
Yeah...I noticed this when I saw the car in person. All the dirt flows out in that section without any restriction.
The whole fender will need a good quality, thick PPF. I does come with a little bit of PPF on the curved part but that wont be enough.
The whole fender will need a good quality, thick PPF. I does come with a little bit of PPF on the curved part but that wont be enough.
#6469
#6470
And as a US-Spec car you will not have all the necessary attachment points in the car. For some odd reason the bottom front (at least) attach points are not included like they are in the ROW chassis version. Something about DOT cert and retrofit capability. Same of course goes for the harness attach points.
#6471
#6472
Addict
Rennlist Member
Rennlist Member
The following users liked this post:
Sean in Texas (06-27-2022)
#6473
I run my GT4 pressures at 32 COLD on all 4 corners. I have found that 32 is a great street setting that gives you responsive turn-in, while not being too harsh. Using the same pressures in the front as the rear also gives the front more bite and eliminate the understeer.
#6474
Yes, mine came with this area protected by factory ppf. However my ppf guys removed it and templated it. After they ppf'ed the entire car, they added a second piece in this area to double protect it, along with double ppf on the bonnet.
#6475
#6476
But yes, PPF would be needed in this area to stop gravel rash on the paint behind the front wheels.
Cheers,
Harry.
Last edited by 998R; 06-25-2022 at 06:56 PM.
#6477
#6478
#6479
Rennlist Member
Not sure if I posted these here…if you’ve seen before….close your eyes.
Saw 7 others in a finished state parked next to each other, waiting for whatever. Couldn’t take pics of these ones as not allowed. Some were gone by the time we walked by that area again.
Saw the engine marriage completed on one, along with a C2S, 911 Turbo and a Boxster of some sort. There were other 4RS going down the line. So they are being actively produced.
Saw 7 others in a finished state parked next to each other, waiting for whatever. Couldn’t take pics of these ones as not allowed. Some were gone by the time we walked by that area again.
Saw the engine marriage completed on one, along with a C2S, 911 Turbo and a Boxster of some sort. There were other 4RS going down the line. So they are being actively produced.
Damn, look at that front lip. Almost dragging on the ground. FAL please.
Last edited by SpyderSenseOC; 06-25-2022 at 07:45 PM.
#6480
The following users liked this post:
Porsche2014 (06-26-2022)