997.1 Dectane LED Lights installed
#122
Is there a video or post that shows the resisters being installed? I saw the video of the light being installed without the resistors. Just got my light in today, look amazing even in the box.
#123
Rennlist Member
Resistor pack has a pigtail electrical connector which plugs into a comparable connector on the lights then it's just a matter of fitting the light and the pack into the fender opening - not difficult at all.
#124
Burning Brakes
It's very easy. The resistors even have 3M double-sided tape already on them. Just peel off the red sticker on the tape, and place the resister inside. I put mine on the pointy side of the light housing in the fender because I knew that it wouldn't interfere with anything on the back of the light in that position. You can't miss the connection to the light.
Last edited by Doug_B_928; 10-26-2011 at 06:55 PM. Reason: clarification "light housing"
#127
Rennlist Member
#128
Burning Brakes
#129
Burning Brakes
#131
Ok ok I should reserve judgement until I see them in person. Thx for the info!
Based on my read, looks like a handful have reported issues with condensation, LEDs going out, and some error codes being thrown.
I wonder how these hold up over time.... Winter, fall.... Hot, cold... Uv.
did any of you order from these US guys?
http://carlightpro.com/where-to-buy/
Based on my read, looks like a handful have reported issues with condensation, LEDs going out, and some error codes being thrown.
I wonder how these hold up over time.... Winter, fall.... Hot, cold... Uv.
did any of you order from these US guys?
http://carlightpro.com/where-to-buy/
Last edited by Aerokitted; 11-05-2011 at 10:00 PM.
#135
Banned
Join Date: Aug 2011
Location: 6feet under snow of CANADA
Posts: 3,665
Likes: 0
Received 0 Likes
on
0 Posts
the group buy ends today on that set it's 1280 for both http://www.6speedonline.com/forums/9...-videos-6.html