View Poll Results: Who's interested in 3D printed door pocket reinforcements?
Yes
69
95.83%
No
3
4.17%
Voters: 72. You may not vote on this poll
Next 3D printing project.....Door Pocket reinforcements.
#226
Rennlist Member
#228
Burning Brakes
I'm inclined to believe that originally, over tightening the door pocket caused stress in bending the plastic which eventually cracked. I used a set on my '88 (& '96) and, when snugged down there was clearance remaining between the original plastic/reinforcement and the mating surface of the door latch. I did not tighten any further or bending would result.
#230
Rennlist Member
Thread Starter
#233
Rennlist Member
Thread Starter
#234
Rennlist Member
Thread Starter
Hey
I somehow managed to delete the Hifi and Non-Hifi door pocket reinforcement plates from Shapeways but I have restored the files now. If they disappear again for any reason, PM me and I will look into it.
https://www.shapeways.com/shops/db993
G
I somehow managed to delete the Hifi and Non-Hifi door pocket reinforcement plates from Shapeways but I have restored the files now. If they disappear again for any reason, PM me and I will look into it.
https://www.shapeways.com/shops/db993
G
#238
Rennlist Member
Thread Starter
#239
Rennlist Member
#240
Rennlist Member
Wow - how did I miss this? I need to check in here more often. Ordered - welcome to the Bay Area! Seen so many changes over the last 42 years...