When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Next 3D printing project.....Door Pocket reinforcements.
I need to make some reinforcements for my door pockets. Tricky enough to measure. I ended using clay to get an imprint. I'm sure it will need adjustment before I call this one ready to go.
Much like my (almost closed) Bumperette delete inserts, I may gauge interest and get a run fabricated if there is enough demand.
I've found that the big problem with these projects is that they cost me a lot to get going due to the high cost of test prints. Unfortunately these are completely necessary yet the most expensive way to printing anything. Printing and shipping one set of things that you know will be wrong is a PITA. I should buy a printer and do it all at home.
IF I end up making these MAYBE I can ship them to parts unknown BUT the shipping cost would have to be figured out. May end up being too expensive to reliably ship them to be worth the effort.
Don't want to put the cart before the horse on these until I start getting test prints back and see where the problems lie.