View Poll Results: Who's interested in 3D printed door pocket reinforcements?
Yes
69
95.83%
No
3
4.17%
Voters: 72. You may not vote on this poll
Next 3D printing project.....Door Pocket reinforcements.
#1
Rennlist Member
Thread Starter
Next 3D printing project.....Door Pocket reinforcements.
I need to make some reinforcements for my door pockets. Tricky enough to measure. I ended using clay to get an imprint. I'm sure it will need adjustment before I call this one ready to go.
Much like my (almost closed) Bumperette delete inserts, I may gauge interest and get a run fabricated if there is enough demand.
https://rennlist.com/forums/993-foru...-who-s-in.html
G
Much like my (almost closed) Bumperette delete inserts, I may gauge interest and get a run fabricated if there is enough demand.
https://rennlist.com/forums/993-foru...-who-s-in.html
G
#5
Rennlist Member
Thread Starter
I've found that the big problem with these projects is that they cost me a lot to get going due to the high cost of test prints. Unfortunately these are completely necessary yet the most expensive way to printing anything. Printing and shipping one set of things that you know will be wrong is a PITA. I should buy a printer and do it all at home.
G
G
Trending Topics
#13
Rennlist Member
#14
Rennlist Member
Thread Starter
Errrr......
IF I end up making these MAYBE I can ship them to parts unknown BUT the shipping cost would have to be figured out. May end up being too expensive to reliably ship them to be worth the effort.
Don't want to put the cart before the horse on these until I start getting test prints back and see where the problems lie.
G
IF I end up making these MAYBE I can ship them to parts unknown BUT the shipping cost would have to be figured out. May end up being too expensive to reliably ship them to be worth the effort.
Don't want to put the cart before the horse on these until I start getting test prints back and see where the problems lie.
G