993 3.8 R outlaw build. My Perfect Porsche.
The following 7 users liked this post by erikerik:
JPMD (07-11-2021),
LimeyBoy (07-10-2021),
MC 968CS (07-11-2021),
olsonreels (07-11-2021),
SpeedyC2 (07-12-2021),
and 2 others liked this post.
#96
Rennlist Member
Thread Starter
I have the parts for the 3.8…. Jeff is a really good salesman! Went in to upgrade my gearbox from aftermarket gears to Genuine RS gears and ended up with a 4.0L too.
the car is making around 400hp with this set up. I could unlock more hp with a GT3 exhaust but decided to keep the stock look.
the car is making around 400hp with this set up. I could unlock more hp with a GT3 exhaust but decided to keep the stock look.
#99
Three Wheelin'
Hi Erik,
Just wanted to let you know that I had the same problem with the PSS10 kit, rear was ok but the front didn't go low enough.
After a little research I found out that FVD makes a collar kit that could lower the car another 4cm.
Just wanted to let you know that I had the same problem with the PSS10 kit, rear was ok but the front didn't go low enough.
After a little research I found out that FVD makes a collar kit that could lower the car another 4cm.
A very slippery slope. GT3's are soo good...
RS uprights would have been nice, but they are on back order and BBI's are a little too expensive in my opinion. Also, uprights aren't necessary for a street car. ERP bump steer kit was enough, but to really get down to RS height you need JRZ or KW coilovers as PSS10's don't let you lower the car enough. Something I learned on my last build.
RS uprights would have been nice, but they are on back order and BBI's are a little too expensive in my opinion. Also, uprights aren't necessary for a street car. ERP bump steer kit was enough, but to really get down to RS height you need JRZ or KW coilovers as PSS10's don't let you lower the car enough. Something I learned on my last build.
#100
Rennlist Member
Thread Starter
3.154
2
1.522
1.242
1.024
0.775
The following users liked this post:
anguilla1980 (07-12-2021)
#104
Rennlist Member
Thread Starter
actually 80k would not even pay for the motor.
#105
Banned
For the 4.0? Parts/labor. Then again, you might have some more unique stuff than I thought. This was based off of JAN20 pricing.
would be cool to see the list (no pricing) on what Jeff does with the 4.0.
would be cool to see the list (no pricing) on what Jeff does with the 4.0.