When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Was hoping this new front splitter would come with installation instructions and hardware, lol. I will have to figure it out and then paint. Might need another weekend to complete.
Was hoping this new front splitter would come with installation instructions and hardware, lol. I will have to figure it out and then paint. Might need another weekend to complete.
what’s your question? I’m guessing the sides have tabs that slide into the spot the old one did? Does it reuse the pull pins? Take a pic underneath and before you installed the splitter. There is only maybe two possibilities on this install… looks great tho
there are only two possible tabs, one on each side of the center opening. But they do not line up with anything. There are no other tabs. I think I can like up an indent under the splitter close to the wheels. So both sides should be able to screw upwards where there is a u nut on each side. The two tabs on the splitter that are close to the middle do not line up with anything, so will drill a hole in undercover and insert expandable nuts. That should hold the center. I still need to find two more spots so there are 3 mounts on each side. not many choices, Only possible spots would be between the two blue tapes in the picture. About 10 inches from wheel well. I will take a picture and post it.
there are only two possible tabs, one on each side of the center opening. But they do not line up with anything. There are no other tabs. I think I can like up an indent under the splitter close to the wheels. So both sides should be able to screw upwards where there is a u nut on each side. The two tabs on the splitter that are close to the middle do not line up with anything, so will drill a hole in undercover and insert expandable nuts. That should hold the center. I still need to find two more spots so there are 3 mounts on each side. not many choices, Only possible spots would be between the two blue tapes in the picture. About 10 inches from wheel well. I will take a picture and post it.
okay so there are 3 push pins that hold up plastic under shields on each side. I would find some plastic maybe 3-5mm think and cut them to go from the bottom of the sides to the push pull pins…make sense?? Then maybe add a couple/few of the well-nuts expanders… maybe a strip of double faces tape??
See pic below:
I don’t know how much material yours have so it’s hard to know
Last edited by GT3twenty10; 12-19-2021 at 08:45 PM.
totally different than mine, I wish I had this setup, lol corner has a screw above it and you can see middle corner has no tab, have to figure this out. This is the only small tab I can screw into the front. You can see they don't line up to original mount
I am trying to figure out a good way to mount it. seems to fit nice but you don't get mounts or instructions. Once I complete it, I will show how I did it.
totally different than mine, I wish I had this setup, lol corner has a screw above it and you can see middle corner has no tab, have to figure this out. This is the only small tab I can screw into the front. You can see they don't line up to original mount
what make is this? Mine is a Joe Toth…
Last edited by GT3twenty10; 12-19-2021 at 09:47 PM.
[QUOTE=starweb93;17853747]its a duraflex product, not Joe Toth, they are different style.[
oh I know there not the same.. there not even close.. you’ll have to get creative, I posted mine with the brand name in case you need to reference… the Joe Toth needed no mods..