What did you do to your 924/944 today
#136
Race Car
I tried Prossi's MAF restrictor today to see how it works. It does pretty darn good w/o a fuel controller. With a fuel controller, it seems it would work very well.
I used a GM AIT sensor as well. It made a nice difference in the drivablilty
This was on my black turbo car, I don't have an NA available right now to test on. When I get back to my 83 I will give more feedback
I used a GM AIT sensor as well. It made a nice difference in the drivablilty
This was on my black turbo car, I don't have an NA available right now to test on. When I get back to my 83 I will give more feedback
#137
Burning Brakes
Join Date: Oct 2006
Location: San Diego (miramar), CA
Posts: 804
Likes: 0
Received 0 Likes
on
0 Posts
Finally installed the 968 spoiler. Makes the rear end look 100x better.
Next:
Cut exhaust
Remove rear seats
Final touches on 968 spoiler
100% interior detail
100% exterior detail
LEAVE IT ALONE FOR A WHILE!
Next:
Cut exhaust
Remove rear seats
Final touches on 968 spoiler
100% interior detail
100% exterior detail
LEAVE IT ALONE FOR A WHILE!
#139
Instructor
Join Date: Nov 2008
Location: Lafayette, LA 70506
Posts: 192
Likes: 0
Received 0 Likes
on
0 Posts
front end
Finally got all the parts in for my turbo style front end. put most of it together haven't bolted all of it down yet since I dropped some bolts down the storm drain.
#141
Went and got some Frost King insulation, stacked layers in the cubbies, put a layer in hatch under carpet, finished up carpet, including sides by rear seat, actually got it out and everything. Not glued in front yet, but everywhere else it is. Layer of frost king under front carpet as well to make it softer and even quieter. Sounds awesome, looks wonderful!
#143
Race Car
installed my new seats tonight,cleaned up the car, buffed the hood a little more. Total weight loss in the last few days ~120#'s
If this clutch will hold up, I may take it up to the track Sunday for some low boost (18 psi) shakedown passes.
If this clutch will hold up, I may take it up to the track Sunday for some low boost (18 psi) shakedown passes.
#147
#149
Almost Addicted
Rennlist Member
Rennlist Member
Ordered:
kevlar belt & roller kit from rennbay
rear hatch seal, pins, and front engine seal kit from automotion
Started a thread asking about which tools I really need for the belts & seals job so I can order those also. I'll just order the full kit tomorrow if I don't get any replies
heading out to the garage to start on my sub boxes.
kevlar belt & roller kit from rennbay
rear hatch seal, pins, and front engine seal kit from automotion
Started a thread asking about which tools I really need for the belts & seals job so I can order those also. I'll just order the full kit tomorrow if I don't get any replies
heading out to the garage to start on my sub boxes.