993 Project continues - Going Wide
#211
Rennlist Member
Thread Starter
Thanks!
The front bumper is ready for some fibreglass and resin. We removed 30mm from the width. Now it fits perfectly. Nevermind the photo, e bumper is just hanging there.
The front bumper is ready for some fibreglass and resin. We removed 30mm from the width. Now it fits perfectly. Nevermind the photo, e bumper is just hanging there.
#214
Rennlist Member
Awesome pics!
#215
Rennlist Member
Thread Starter
I received the 35mm spacers today but ofcourse they didn't fit...
The existing bolts extend too far out so I have to cut them shorter and the bolts on the spacers are too short for the BBS wheels.
So I pushed one of the bolts out today, took measurements and ordered new, longer bolt.
Next winter I can re-build the wheels with to correct offset and I can replace the bolts and bearings.
A couple of shots of the front bumper. The fitment is now 10/10 (not in the photo as it is not fixed). I have already made arrangements for taking moulds of the bumper and the front lip so I can easily produce spares if needed.
It might be possible to make them for other people as well but I'd have to check with GT racing that it is ok with them.
The existing bolts extend too far out so I have to cut them shorter and the bolts on the spacers are too short for the BBS wheels.
So I pushed one of the bolts out today, took measurements and ordered new, longer bolt.
Next winter I can re-build the wheels with to correct offset and I can replace the bolts and bearings.
A couple of shots of the front bumper. The fitment is now 10/10 (not in the photo as it is not fixed). I have already made arrangements for taking moulds of the bumper and the front lip so I can easily produce spares if needed.
It might be possible to make them for other people as well but I'd have to check with GT racing that it is ok with them.
#216
Rennlist Member
I am not sure I would go as wide as you are but I do really like the look of that front lip.
#218
Rennlist Member
Thread Starter
Some progress here for a change. I had some spare time tonight so I finished the oil cooler brackets. The passenger side cooler is in place now but the drivers side bracket needs a little welding before it's completely ready.
I will install some rubber trim on the cooler opening to completely seal the perimeter of the cooler. Now there are gaps everywhere.
The front bumper is also back together. Some fiberglass cloth, resin and bondo do wonders...
After the bumper has been painted I will take moulds out of it.
I will install some rubber trim on the cooler opening to completely seal the perimeter of the cooler. Now there are gaps everywhere.
The front bumper is also back together. Some fiberglass cloth, resin and bondo do wonders...
After the bumper has been painted I will take moulds out of it.
#219
Looking great!
#221
Rennlist Member
Thread Starter
#222
The front bumper looks awesome. Who's painting the car?
Ken
Ken
#224
Basic Sponsor
Rennlist
Site Sponsor
Rennlist
Site Sponsor
Looking good!
__________________
Your Trusted Source For DIY and Parts
FREE SHIPPING over $99 click here
Porsche Parts | DIY Tech Articles | Facebook | Twitter | Instagram | YouTube | Promos
888.280.7799 | 6am - 5pm PST
FREE SHIPPING over $99 click here
Porsche Parts | DIY Tech Articles | Facebook | Twitter | Instagram | YouTube | Promos
888.280.7799 | 6am - 5pm PST
#225
Rennlist Member
Thread Starter
I got the parts for the Kinesis wheels today. I will assemble them when I get the time, this weekend we are racing at Botniaring.
My garage looks like a wheel shop...
My garage looks like a wheel shop...