What did you buy your 991 today thread
#7726
Advanced
#7727
got a lot done over the weekend!
picked the car up post eibach install/alignment. BCforged MLE81 went on. New soul 4" slant cut tips. New front sport lip, replaced inner door sill trim pieces and most importantly got drive it a bit!
picked the car up post eibach install/alignment. BCforged MLE81 went on. New soul 4" slant cut tips. New front sport lip, replaced inner door sill trim pieces and most importantly got drive it a bit!
The following 8 users liked this post by jpu1:
ash_schwin (03-08-2023),
Clubber (03-10-2023),
jesm (03-09-2023),
MingusDew (03-09-2023),
Nixin (03-09-2023),
and 3 others liked this post.
#7730
https://www.suncoastparts.com/product/991DSILLDR.html
https://www.suncoastparts.com/produc...SE_Interioracc
https://www.suncoastparts.com/product/SKUG2991SL.html
The passenger side trim piece takes about 2 minutes, pop the old one off with a trim removal tool, pull back weather stripping, reinstall new piece and reinstall weather stripping. Driver side admittedly took a little longer since you have to transfer over the frunk/rear switch, I may have been doing it wrong, but I didn't see an obvious release for the switch so I really had to wrestle it out. Front lip pops right off and new one on very easily. An hour all in for everything and a much cleaner result. Worth it imo.
The following users liked this post:
ash_schwin (03-09-2023)
The following users liked this post:
Clubber (03-10-2023)
#7732
Rennlist Member
Carbon Fiber rear engine hatch louvers from Rennline.
#7733
Rennlist Member
Been looking at these wheels for a while. Are yours 20" or 19"?
#7734
20x9 +40/11.5 +62
I went back and forth on specs for a few days, lots of research on others setups and arrived on these numbers, I like a more flush fitment then most I think, so can always bump the offset up if you don't like the stance. With that being said nowhere close to rubbing when driving the car hard. I do have RAS, so I don't know how many 19" wheels work without swapping some hardware in the rear based on what I was told by the guys @supremepower
I went back and forth on specs for a few days, lots of research on others setups and arrived on these numbers, I like a more flush fitment then most I think, so can always bump the offset up if you don't like the stance. With that being said nowhere close to rubbing when driving the car hard. I do have RAS, so I don't know how many 19" wheels work without swapping some hardware in the rear based on what I was told by the guys @supremepower
The following users liked this post:
Silversun262 (03-09-2023)
#7735
Rennlist Member
Thank you for the info!
#7737
Rennlist Member
#7739
Three Wheelin'
Some people add it, but the flare/triangle stuff is already there if you do European delivery, because it is required for driving in Europe so the car, while destined for the US, still leaves the factory ready for the autobahn.