When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
it has the GIAC tune on it...now it’s time to decide on either going with full bolt ons and keeping it simple, or going the bigger turbo route.
the simplest path to about 750 ish HP and TQ with plenty of mid rpm range punch would be ideal...any suggestions guys?
Gotcha - modding is a slippery slope
I just went for Cobb tune and Kline exhaust headers (through Sam at Bydesign) and its probably fast enough for me. I can barely use what i have now without getting super-arrested or being reckless. But i won't rule out something in the future.
The new front lip is on...I went a little Frankenstein here.
The front end needed a bit of extra drama to it to match the back end...but tastefully so...instead of going the route of a full RS front end replacement I saw and fell in love with the factory Aerokit Upgrade front lip.
but I didn’t like the whole kit, just the front lip...Suncoast recently made just the front lip available so instead of the front lip, sideskirts, and rear wing all the same factory AeroKit I have the Factory front lip upgrade, with the standard TTS rear wing, and the wider RS sideskirts from Suncoast.
car is Very Close to completion.
Last edited by Steven31371; 04-25-2020 at 04:35 PM.
The new front lip is on...I went a little Frankenstein here.
The front end needed a bit of extra drama to it to match the back end...but tastefully so...instead of going the route of a full RS front end replacement I saw and fell in love with the factory Aerokit Upgrade front lip.
but I didn’t like the whole kit, just the front lip...Suncoast recently made just the front lip available so instead of the front lip, sideskirts, and rear wing all the same factory AeroKit I have the Factory front lip upgrade, with the standard TTS rear wing, and the wider RS sideskirts from Suncoast.
car is Very Close to completion.
That demonstrates an incredible amount of patience - I cannot even imagine how hard, and what tiny little fingers are needed, to complete a job like that. Out of curiosity, does it have any power adders?
That demonstrates an incredible amount of patience - I cannot even imagine how hard, and what tiny little fingers are needed, to complete a job like that. Out of curiosity, does it have any power adders?
Has a GIAC tune so far...next set of mods will be bolt ons...want to get it to 700-750 ish horsepower and torque
Well thanks 2f...I was blessed with two fantastic girls..she just returned from University of Melbourne with her masters..(that was cheap ) and now wants to start phd ...the other is completing second degree...so I guess it's work for eternity for me
Well thanks 2f...I was blessed with two fantastic girls..she just returned from University of Melbourne with her masters..(that was cheap ) and now wants to start phd ...the other is completing second degree...so I guess it's work for eternity for me
yeah but that’s good work, with ‘purpose’ to it....improving the economic trajectory of your family for the next two or three generations. 💪🏻💪🏻💪🏻
04-25-2020, 03:26 PM
) and now wants to start phd ...the other is completing second degree...so I guess it's work for eternity for me 