Project 300RWHP on a buget.. info needed.
07-23-2004 | 07:00 PM
#121
UAE Rennlist Ambassador
Rennlist Member
Rennlist Member
Joined: Jan 2004
Posts: 9,142
Likes: 3
From: UAE & Germany
18psi.....At this point a Ta or Z28 isiint worth the gas and I can safely pull ls1 c5's by 5-6 car link's
20psi.....ls1 c5's aren't worth the gas. I could prolly pull older viper's without much trouble(never got the chance) and would like to run into a 996tt. I pull 1-2 car's on zo6's.
20psi.....ls1 c5's aren't worth the gas. I could prolly pull older viper's without much trouble(never got the chance) and would like to run into a 996tt. I pull 1-2 car's on zo6's.
07-23-2004 | 08:18 PM
#122
Advanced
Joined: Oct 2003
Posts: 59
Likes: 0
From: puerto rico
in my old k 27/6 , i bored the compresor housing and the back plate. i instal a k 27 wheel
the inducer are 2 or 3 mm larger and the exducer 3 inch , with that modifications the k26/6 hold me 18 lbs to redline.
the inducer are 2 or 3 mm larger and the exducer 3 inch , with that modifications the k26/6 hold me 18 lbs to redline.
07-24-2004 | 12:17 AM
#123
UAE Rennlist Ambassador
Rennlist Member
Rennlist Member
Joined: Jan 2004
Posts: 9,142
Likes: 3
From: UAE & Germany
It would not, If you have the Tial or a good wastegate. It should drop to roughlt 16psi at redline or so.
Soemone earlier posted his dyno run after adding chips, test pipe and tial wastegate. He got 15 psi and dropped to 14 at redline. So it wouldn't drop much like the factory wastegate does.
Soemone earlier posted his dyno run after adding chips, test pipe and tial wastegate. He got 15 psi and dropped to 14 at redline. So it wouldn't drop much like the factory wastegate does.
