New DEVEK level 2 headers
#1
Addict
Rennlist Member
Rennlist Member
Thread Starter
Join Date: Dec 2003
Location: Houston
Posts: 144
Likes: 0
Received 0 Likes
on
0 Posts
New DEVEK level 2 headers
I have the last 5 sets of DEVEK level 2 headers (1-3/4" primaries). THESE ARE NEW. Fit all years.
Bought them because they really are great headers and they'd be scrap now if I didn't. I love them on my S4 too!
I am looking to sell them. I posted in the classified section but I thought this forum group would like know about them be available.
Guy 713.302.0429
Bought them because they really are great headers and they'd be scrap now if I didn't. I love them on my S4 too!
I am looking to sell them. I posted in the classified section but I thought this forum group would like know about them be available.
Guy 713.302.0429
Trending Topics
#8
Supercharged
Rennlist Member
Rennlist Member
Join Date: May 2002
Location: Back in Michigan - Full time!
Posts: 18,925
Likes: 0
Received 59 Likes
on
33 Posts
I love mine. Wicked sound, PITA to install. congrats to whoever get these. Had I been sharp I woud have bought them just becasue they are so good, I want another set just in case something happens the ones I already have..
#9
Drifting
Were you able to install yours without pulling the engine?
Thx
#10
Supercharged
Rennlist Member
Rennlist Member
Join Date: May 2002
Location: Back in Michigan - Full time!
Posts: 18,925
Likes: 0
Received 59 Likes
on
33 Posts
MJ... if you are the lucky guy, just get them and send them to me. It's your only hope.
But yes. I installed them without pulling the motor... In fact, I don't think you can install the motor with them on (at least from above). I'm actually getting ready to pull my motor again and I'm thinking I might try dropping it down and through, rather than to go up and out.
Your biggest issue will be getting the rest of the exhaust fabbed. I drove my car 20 miles with open headers on a cold February day a couple years back to have a guy fab up the rest of the exhaust. OMG! My ears were ringing for a week!
But yes. I installed them without pulling the motor... In fact, I don't think you can install the motor with them on (at least from above). I'm actually getting ready to pull my motor again and I'm thinking I might try dropping it down and through, rather than to go up and out.
Your biggest issue will be getting the rest of the exhaust fabbed. I drove my car 20 miles with open headers on a cold February day a couple years back to have a guy fab up the rest of the exhaust. OMG! My ears were ringing for a week!
#11
Drifting
MJ... if you are the lucky guy, just get them and send them to me. It's your only hope.
But yes. I installed them without pulling the motor... In fact, I don't think you can install the motor with them on (at least from above). I'm actually getting ready to pull my motor again and I'm thinking I might try dropping it down and through, rather than to go up and out.
Your biggest issue will be getting the rest of the exhaust fabbed. I drove my car 20 miles with open headers on a cold February day a couple years back to have a guy fab up the rest of the exhaust. OMG! My ears were ringing for a week!
But yes. I installed them without pulling the motor... In fact, I don't think you can install the motor with them on (at least from above). I'm actually getting ready to pull my motor again and I'm thinking I might try dropping it down and through, rather than to go up and out.
Your biggest issue will be getting the rest of the exhaust fabbed. I drove my car 20 miles with open headers on a cold February day a couple years back to have a guy fab up the rest of the exhaust. OMG! My ears were ringing for a week!
For some reason I was thinking theres an X-pipe that would match up to these, apparently not...Grrr!
Thanks for the info bud
#12
#13
Drifting