Need banjo fitting for intake manifold
#1
Race Car
Thread Starter
Join Date: Mar 2012
Location: Austin TX, drinking beer in the garage
Posts: 3,602
Likes: 0
Received 7 Likes
on
7 Posts
Need banjo fitting for intake manifold
I somehow lost one of the four 1/8" hose barb fittings from my 951. I dont need the hollow banjo bolt, just a vacuum line fitting and a pair of the correct aluminum crush washers. Anyone have one or know where to get them cheap?
#3
Rennlist Member
Depending on if you wanted a threaded or barbed end, I buy my banjo fittings from these guys:
https://www.pegasusautoracing.com/ke...banjo+aluminum
https://www.pegasusautoracing.com/ke...banjo+aluminum
#4
Race Car
Thread Starter
Join Date: Mar 2012
Location: Austin TX, drinking beer in the garage
Posts: 3,602
Likes: 0
Received 7 Likes
on
7 Posts
Damn, this is going to end up costing me over $20 just for that fitting. Does anyone have one of these fittings and 2 aluminum crush washers laying around that they'd be willing to throw into an envelope and ship for a lot less than 20 bucks?
#6
Rainman
Rennlist Member
Rennlist Member
what size are the banjos "ID"?
perhaps a weird solution, but it might work...I am replacing the brake hoses on my subaru and they are 8mm banjo fittings.
if you want em you can have my old ones for the $7 itll cost to ship...you can have all 4, but you'll have to remove the hose first
perhaps a weird solution, but it might work...I am replacing the brake hoses on my subaru and they are 8mm banjo fittings.
if you want em you can have my old ones for the $7 itll cost to ship...you can have all 4, but you'll have to remove the hose first
Trending Topics
#11
Rennlist Member
Found my old ones, I knew they were around here somewhere. PM me your address and I'll mail one out along with an extra washer.
#12
Race Car
Thread Starter
Join Date: Mar 2012
Location: Austin TX, drinking beer in the garage
Posts: 3,602
Likes: 0
Received 7 Likes
on
7 Posts
Thanks so much!!! I'm just concerned about buying random aftermarket fittings because of possible issues with the height of the fitting and sealing issues. I'd feel way better with an OEM fitting. PM on the way.
#13
Rennlist Member
These are OEM, off an 89 turbo.
It looks like you only need one washer but let me know if you want two.
I'm heading to the post office in the morning and can get these out, PM me when you get the chance.
It looks like you only need one washer but let me know if you want two.
I'm heading to the post office in the morning and can get these out, PM me when you get the chance.
Last edited by mj951; 04-06-2017 at 09:22 PM.