My 964 C2 Transformation Build Thread
#557
Rennlist Member
Thread Starter
901 miles until it's worthless!
Ccu all cleaned up, was very dusty inside,cleaned and oiled fan, etc.
Switch installed and working well.
Ccu all cleaned up, was very dusty inside,cleaned and oiled fan, etc.
Switch installed and working well.
#558
Rennlist Member
Thread Starter
Another track shot from a couple weeks ago. Can't recall if I posted :-)
Just waiting for a slot to drop the 964 off at BBI to finish the build (well phase 1 of it). Probably next 2 weeks.
Then I'll have rear cage, safety equipment, light flywheel, trans and motor mounts, shifter, exhaust system and a few other goodies....!!!
Just waiting for a slot to drop the 964 off at BBI to finish the build (well phase 1 of it). Probably next 2 weeks.
Then I'll have rear cage, safety equipment, light flywheel, trans and motor mounts, shifter, exhaust system and a few other goodies....!!!
#559
Another track shot from a couple weeks ago. Can't recall if I posted :-) Just waiting for a slot to drop the 964 off at BBI to finish the build (well phase 1 of it). Probably next 2 weeks. Then I'll have rear cage, safety equipment, light flywheel, trans and motor mounts, shifter, exhaust system and a few other goodies....!!!
#562
Rennlist Member
Thread Starter
#563
Rennlist Member
Thread Starter
#565
#566
Instructor
Join Date: Apr 2016
Location: Scotts Valley, CA
Posts: 190
Likes: 0
Received 0 Likes
on
0 Posts
#567
Rennlist Member
Thread Starter
Finally got this lower trim part in for the steering column. No hole for cruise. Ok maybe overly obsessive but it was only $25
#570
Rennlist Member
Thread Starter