Battery Dead...
#46
I'll check out Costco and see if they also have Group 48.
Definitely will Dan. We talked earlier about hooking up but the season got away on us. I keep a Nautique out at Puslinch so would be happy to meet up with you and give you a pull.
How are you likeing the TT?
Regards,
Paul.
are you gonna be skiing this year if the snow ever melts?
How are you likeing the TT?
Regards,
Paul.
#49
Rennlist Member
I'll check out Costco and see if they also have Group 48.
Definitely will Dan. We talked earlier about hooking up but the season got away on us. I keep a Nautique out at Puslinch so would be happy to meet up with you and give you a pull.
How are you likeing the TT?
Regards,
Paul.
Definitely will Dan. We talked earlier about hooking up but the season got away on us. I keep a Nautique out at Puslinch so would be happy to meet up with you and give you a pull.
How are you likeing the TT?
Regards,
Paul.
I am loving the tt, thanx.
#51
Rennlist Member
be sure to disconnect the negative first and then the positive then the bolt which holds down the battery, (you may need to use a socket with extension) then pull the battery clean the battery leads then the positive next connect the negative. if done in this order you sould have no risk of damage to you or vehicle.
very easy to do. good luck
very easy to do. good luck
#52
Burning Brakes
Also do not wear jewellery, including any rings or chains.
To reconnect, reverse what Turbodan said, starting at the positive first.
If for some reason you close the circuit touching a ring in your finger, 700 Amps
could burn EDIT: the ring right to the bone in a short moment- so be careful.
John
To reconnect, reverse what Turbodan said, starting at the positive first.
If for some reason you close the circuit touching a ring in your finger, 700 Amps
could burn EDIT: the ring right to the bone in a short moment- so be careful.
John
Last edited by JDSStudios; 03-28-2008 at 07:12 AM.
#54
Nordschleife Master
#56
Nordschleife Master
I think mine is just 4" and it did the job.
The combo wrench is just to take the terminal connector off the post.