Oil change 997 gt3
#46
Rennlist Member
If you jacked the back of the car, oil went to the front and you might not have drained it all. I drain my car flat on the ground, using the flat plastic pan.
JB
JB
#47
says oil capacity 9 litres?
#48
Rennlist Member
Your'e good to go.
Question, why is there two oil change threads started by the same member? Mods merge!
Question, why is there two oil change threads started by the same member? Mods merge!
Last edited by RAudi Driver; 04-23-2023 at 11:08 AM.
#49
#50
Instructor
I installed one of these on my oil reservoir (https://www.stahlbus-us.com/stahlbus...acing-cap.html)
Oil changes much cleaner, easier and faster now I do them for fun
Oil changes much cleaner, easier and faster now I do them for fun
#51
I installed one of these on my oil reservoir (https://www.stahlbus-us.com/stahlbus...acing-cap.html)
Oil changes much cleaner, easier and faster now I do them for fun
Oil changes much cleaner, easier and faster now I do them for fun
The following users liked this post:
996TS (04-25-2023)
#52
Rennlist Member
Originally Posted by norwegen911
agree, installed on both crankcase and oiltank
#53
I am not an expert but you will see when you install
Last edited by norwegen911; 04-25-2023 at 08:39 AM.
The following users liked this post:
996TS (04-25-2023)
#55
Doing the oil change jacking up the car will not drain all the oil and the safe procedure when refilling is to add only 8 qts and let the oil circulate a few minutes before measuring with the electronic sensor. I do my oil changes using a lift and first drain the engine sump (2-3 quarts) then the side holding tank. I refill with 8 quarts and idle the engine and maybe add another qt to reach 1 bar below max. It is bad to overfill any Porsche engine as that defeats the purpose of having a dry sump lubrication system.
#56
Instructor
#57
Drifting
#58
Rennlist Member
#59
Drifting
#60
Rennlist Member