Anyone have any pictures of their installed cup brake ducts? I need to install them and before I get going, I always like a visual.

 

Only pic I found on my computer.

 

Just look at how the OEM ducts are installed and install the Cup ones in the same way. It's a piece of cake!

 

You'll want to use two zip ties as well. Just need to drill some holes in the plastic.

 

Where did you instal zip ties?

 

Not sure if you can see in my picture but I drilled a small hole at the top of the duct about the mid point of the leading arm and then ran a zip tie through it and around the arm. The zip isn't pictured but the hole is. I must have taken this pic before I ran a new zip tie through it.

 

Attachment 252935

 

Thanks Rob

 

I thought that was the hold Dell was referring to. Thanks for highlighting that Rob. Nice job!

 

I need to buy a right side Cup brake duct (lost it this weekend). Do you have the part#?

 

left/996.341.117.90
right/996.341.118.90

 

Fast Rob!!!! Beat me to it.

Here are the p/n's as well for stock and RS:

996.341.117.91 GT3 left
996.341.118.91 GT3 right

996.341.117.92 GT3RS left
996.341.118.92 GT3RS right

996.341.117.90 GT3Cup left
996.341.118.90 GT3Cup right

 

When I bought my ducts from viperbob, he described them as Motorsport ducts. Does that apply to either the RS or Cup ducts, or is it one specific set?

 

Just the cups.

 

I thought I saw a GT3 cup duct on the pit out lane at Laguna off the front straight....I have to say I laughed at the fact I knew it was a GT3 cup duct, even driving by at pit out speed.