Cup Car Brake Duct DIY
#1
Addict
Rennlist Member
Rennlist Member
Thread Starter
Cup Car Brake Duct DIY
Anyone have any pictures of their installed cup brake ducts? I need to install them and before I get going, I always like a visual.
#6
Nordschleife Master
Not sure if you can see in my picture but I drilled a small hole at the top of the duct about the mid point of the leading arm and then ran a zip tie through it and around the arm. The zip isn't pictured but the hole is. I must have taken this pic before I ran a new zip tie through it.
Trending Topics
#9
Addict
Rennlist Member
Rennlist Member
Thread Starter
I thought that was the hold Dell was referring to. Thanks for highlighting that Rob. Nice job!
#12
Nordschleife Master
Fast Rob!!!! Beat me to it.
Here are the p/n's as well for stock and RS:
996.341.117.91 GT3 left
996.341.118.91 GT3 right
996.341.117.92 GT3RS left
996.341.118.92 GT3RS right
996.341.117.90 GT3Cup left
996.341.118.90 GT3Cup right
Here are the p/n's as well for stock and RS:
996.341.117.91 GT3 left
996.341.118.91 GT3 right
996.341.117.92 GT3RS left
996.341.118.92 GT3RS right
996.341.117.90 GT3Cup left
996.341.118.90 GT3Cup right
#13
Addict
Rennlist Member
Rennlist Member
When I bought my ducts from viperbob, he described them as Motorsport ducts. Does that apply to either the RS or Cup ducts, or is it one specific set?
#14
Three Wheelin'
#15
I thought I saw a GT3 cup duct on the pit out lane at Laguna off the front straight....I have to say I laughed at the fact I knew it was a GT3 cup duct, even driving by at pit out speed.