When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Yup outstanding!
Good job to you and mike on the suspension, must have been fun. We're getting some great driving weather - enjoy!
Well, I guess "fun" is a relative term. . It actually was not too bad on the lift with some air tools - the subframe bushings came out without too much drama but the air chisel was essential since they were done in the car. I would hate to do the whole thing with just a hammer, I started each bushing by hand and then finished with the tool once i had enough clearance so I knew we would not damage the subframe.
Luckily, we did not get any stuck ball joints, so the rest went well. We did it all without pushing the driveshafts out which was great, I do have the torque wrench to do the wheel nuts, but do not like like to risk pushing the Turbo shafts out of the hubs to due to their internal vent shafts.