Hole saw question for the fabricators here
12-12-2008, 12:30 PM
#16
Beautiful work.
You could also post the question at www.metalmeet.com.
Forum URL:http://www.metalmeet.com/forum/index.php
You could also post the question at www.metalmeet.com.
Forum URL:http://www.metalmeet.com/forum/index.php
12-12-2008, 12:33 PM
#17
Addict
Rennlist Member
Rennlist Member
Id do it with a nibbler or band saw around the outside and a belt sander to finish up
these guys will make em for ya
http://www.wagnercompanies.com/Disks...FQMCagod5CKKRw
these guys will make em for ya
http://www.wagnercompanies.com/Disks...FQMCagod5CKKRw
12-12-2008, 02:20 PM
#18
Seared
Rennlist Member
Rennlist Member
Thread Starter
Id do it with a nibbler or band saw around the outside and a belt sander to finish up
these guys will make em for ya
http://www.wagnercompanies.com/Disks...FQMCagod5CKKRw
these guys will make em for ya
http://www.wagnercompanies.com/Disks...FQMCagod5CKKRw
Too funny! I've ordered quite a few 1/4"-thick discs and other steel parts from them in the past. Think, 993 Hose Reel......
Andreas
Last edited by AOW162435; 12-12-2008 at 08:34 PM.
12-12-2008, 08:11 PM
#19
What you need is a knockout punch like electricians use for punching holes in electrical boxes.
Greenlee makes them and they are easy to use. http://www.mygreenlee.com/Products/m...db_next_page=1
I don't know if it'll do the 4.5" you need.
Greenlee makes them and they are easy to use. http://www.mygreenlee.com/Products/m...db_next_page=1
I don't know if it'll do the 4.5" you need.
